Minka Lavery 759-2-XX-L Vantage 1 Light LED Ashen Brass Flush Mount Instruction Manual

Table of Contents

Minka-Lavery-759-2-XX-L-Vantage-1-Light-LED-Ashen-Brass-Flush-Mount-
PRODUCT

Specifications:

Item Numbers: 759-2-XX-L, 769-2-XX-L
Dimming Compatibility: Dimmable with ELV and/or LED-compatible wall dimmer switches

Preparation:

Shut off power at the fuse box or circuit breaker and remove the old fixture along with its mounting hardware.
Unpack the new fixture and ensure all parts are laid out in a clean area without misplacing any small parts.

Installation & Assembly:

Attach the mounting plate (B) to the outlet box (A) using the provided outlet box screws (C).
Secure the support cable (F) to the slotted holes on the mounting plate (B) ensuring it can support the fixture’s weight during wiring.
Connect the black supply wire to the black fixture wire, the white supply wire to the white fixture wire, and join the fixture ground wire with the supply ground wire using wire nuts (D). Secure connections with electrical tape.
Tuck all wires and connections carefully into the outlet box (A).
Raise the fixture body, align the tab to the clamping position (E) of the mounting plate (B), push upward, rotate to install, and tighten.

IMPORTANT:
Fixture installation should be done by a qualified electrician to ensure proper wiring and installation.

Care and Maintenance:
Use a clean, soft cloth to wipe the surface of the fixture. Avoid cleaners with chemicals, solvents, or harsh abrasives.

Dimming:
The fixture is dimmable with ELV and/or LED-compatible wall dimmer switches.

FAQ

Q: Can I use this fixture with a standard dimmer switch?
A: No, this fixture is only compatible with ELV and/or LED-compatible wall dimmer switches.
Q: How do I ensure a secure connection when wiring the fixture?
A: Connect the wires following the provided instructions and use wire nuts (D) to join them together. Wrap all connections with electrical tape for added security.

WARNING!
SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

READ AND SAVE THESE INSTRUCTIONS

Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.

INSTALLATION & ASSEMBLY (Fig.1 & Fig.2)

IMPORTANT:
FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.

Attach mounting plate (B) to outlet box (A) (Not included) using the outlet box screws (C) provided.
Attach support cable (F) to the slotted holes on mounting plate (B), care, and fully allow support cable (F) to support the weight of the fixture while wiring.
Pull power supply wires out from outlet box (A). Connect the black supply wire to the black fixture wire using wire nut (D). Connect the white supply wire to the white fixture wire using wire nut (D). Connect the fixture ground wire and the supply ground wire using wire nut (D). Wrap all wire connections with electrical tape for a more secure connection.
Carefully tuck all wires and wire connections into outlet box (A).
Raise the fixture body and align the tab to the clamping position ( E ) of the mounting plate ( B ). Push upward and rotate to install until tightening.

Your installation is now complete. Return power and test the fixture.