MINKA LAVERY 5296-66A Breakers Isle 6 Light Black and Soft Brass Semi Flush Instruction Manual

MINKA LAVERY 5296-66A Breakers Isle 6 Light Black and Soft Brass Semi-

Flush

WARNING!
SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

PREPARATION

1. Shut off the power at the fuse box or circuit breaker box. If necessary, remove the old fixture and all mounting hardware from the junction box (not provided).

2. Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any parts necessary for installation.
   ASSEMBLING THE FIXTURE

3. Install ring (R) onto ring (Q), and secure with screws (P).
   PENDANT:(Fig.1)

4. Determine the desired hanging height and thread rods (K, L, M, N) to coupling (O). Then thread loop (J) onto rod (K). Pass wires carefully through each rod and loop (J).
   SEMI FLUSH MOUNT:(Fig.2)

5. Thread loop (J) into coupling (O).
   MOUNTING THE FIXTURE (Fig.1)

6. Secure crossbar (A) to junction box (Not provided) with junction box screws (B) (Size: #8- 32*0.6” L).Thread nut (D) onto all thread (E) so five threads are exposed above the nut (D). Insert lock washer (C) and thread all thread (E) into the crossbar (A), then secure with nut (D). The side of the crossbar (A) marked “GND” must face out.

7. Thread collar loop (G) onto all thread (E).

8. Slip lock collar (H) and canopy (F) over loop (J) and rods, allowing them to rest on fixture coupling (O).

9. Use quick link (I) to connect loop (J) and collar loop (G).

10. Feed fixture wires through collar loop (G), and all thread (E).
    CONNECTING THE WIRES (Fig.3)

11. Connect the electrical wires as shown in Fig.2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect ground wires to it. Otherwise, connect the ground wire directly to the crossbar (A) and secure using the green screw provided.

12. Tuck wire connectors neatly into the junction box.
    COMPLETING THE INSTALLATION (Fig. 1)

13. Raise canopy (F) to ceiling. Then raise the lock collar (H) and thread onto the collar loop (G) protruding through the canopy (F).

14. Install (6) six candelabra base bulbs up to 60 watts each or CFL or LED equivalent (not included) according to the fixture specification. (DO NOT EXCEED THE SPECIFIED WATTAGE!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)

15. Install glass plate (T) onto rings (Q, R), then secure with washer (S) and screw (U). Your installation is now complete. Return the power to the junction box and test the fixture.

Hardware Bag

• A. Cross Bar *1

• B. Junction Box Screws *2

• C. Lock Washer *1

• D. Hex Nut *1

• E. All Thread *1

• F. Canopy 1
  G. Collar Loop 1

• H. Lock Collar *1

• I. Quick Link *1

• J. Loop *1

Hardware Bag

• L, M, N. Rod 12’’ *3
• K. Rod 6” *1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>