Minka Lavery 747396126456 Zinola 1 Light Sand Black and Halcyon Gold LED Flush Mount Instruction Manual
- June 2, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 747396126456 Zinola 1 Light Sand Black and Halcyon Gold LED Flush Mount
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIR CUITBRE AKER .
HANGING THE FIXTURE (Fig. 1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
- Loosen screws (A) and separate mounting plate (B) from canopy (D).
- Secure mounting plate (B) to junction box (H) (Not included) using mounting screws (F) (Size: #8-32N*25mmL) provided. The side of mounting plate (B) marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2
- Connect the electrical wires as shown in (Fig.2), making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise, connect the fixture ground wire directly to mounting plate (B) using the green screw provided.
- After wires are connected, tuck them carefully inside junction box.
FINISH THE INSTALLATION (Fig. 1)
- Place canopy (D) over mounting plate (B) and secure with screws (A).
- Gently twist Shade (E) onto the bottom of canopy (D). Do not over tighten.
REPLACING LED MODULE(Fig.3)
The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached. See installation steps for more details (Fig 3.)
- a. Shut off the power.
- b. To remove fixture from ceiling, loosen screws (A) and canopy (D) from mounting plate (B). Disconnect wire connectors and place fixture on a clean surface.
- c. Gently twist shade (E) out of the bottom of canopy (D).
- d. Loosen screws (I), remove lamp shape (J), and remove LED module (K) from canopy (D).
- e. Reverse steps b-d for installing the new LED module.
Your installation is complete now. Return power to the junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION
Dimmable with ELV and/or LED compatible wall dimmer switches.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>