CREATIVE EF1040 Bluetooth Wireless Over-Ear Headset

Specifications:

• Model No.: EF1040
• Bluetooth headset
• Compliance with Directive 2014/53/EU and Radio Equipment Regulations 2017
• USB-C Charging Port
• Hybrid Active Noise Cancellation (ANC)
• Detachable Boom Microphone available for specific bundles
• RGB LED Rings
• Omni-directional Microphone
• Adjustable Slider with Length Markings

Product Usage Instructions

Controls:

Powering On / Off:

• Press the Power Button for 1 second to turn the device on (LED blinks red then blue).
• To power off, press the Power Button for 1 second (LED blinks red then turns off).

Headphones Control:

• Press the designated button once to control the headphones.

Pairing Instructions:

CREATIVE ZEN HYBRID PRO:

• To pair with a device, press and hold the Bluetooth Pairing Button for 4 seconds (LED flashes blue).
• When paired, the LED will show a solid blue light for different modes.

MULTIPOINT PAIRING:

1. To connect to a second device, press and hold the Multifunction button for 4 seconds to initiate Bluetooth pairing.
2. Select the headphones on the second device to complete the pairing.
3. The headphones will automatically reconnect to the last two paired devices when powered on.

Battery Charging:

• When charging, the LED indicator will show solid red.
• Once fully charged, the LED indicator will display solid green.
• If the battery level is below 10%, the LED will flash red.
• The device will automatically power off when plugged in for charging.

FAQ

• Q: Can I use the Bluetooth headset while charging?
  • A: Yes, you can use the Bluetooth headset while it is charging. However, please note that the device will automatically power off when plugged in for charging.
• Q: How do I know if the Bluetooth headset is fully charged?
  • A: The LED indicator will show a solid green light when the Bluetooth headset is fully charged.

OVERVIEW

1. Comfort-boosting Padded Headband
2. Adjustable Slider with Length Markings
3. Next Track Button
4. Previous Track Button
5. RGB LED Rings
6. Mic Mute / Unmute Button
7. Charging LED Indicator
8. USB-C Charging Port
9. Multifunction Button (Power / Bluetooth® Pairing)
10. Omni-directional Microphone
11. Detachable Boom Mic Input Port
12. Hybrid Active Noise Cancellation (ANC) Button
13. Play / Pause Button
14. Volume Dial
15. LED Status Indicator

DETACHABLE BOOM MICROPHONE

AVAILABLE FOR ZEN HYBRID PRO CLASSIC AND ZEN HYBRID PRO SXFI BUNDLES ONLY

Caution : Avoid connecting or disconnecting the Boom Microphone while engaged in calls or online chats to prevent potential disruptions that may result in audio being abruptly interrupted.

CONTROLS

Powering On / Of

Headphones Control

Call Function

Noise Control

PAIRING INSTRUCTIONS

CREATIVE ZEN HYBRID PRO

MULTIPOINT PAIRING

1. To connect to a second device, press and hold the Multifunction button for 4 seconds to manually initiate Bluetooth pairing on the headphones. Select the headphones under “Available Devices” on the second device to pair.
2. Once paired to the second device, Creative Zen Hybrid Pro will automatically reconnect to the last two paired devices when powered on.

BATTERY CHARGING

Creative Zen Hybrid Pro will automatically power off when plugged in for charging

MASTER RESET

CREATIVE ZEN HYBRID PRO

Press and hold the Mic Mute / Unmute button for 10 seconds to perform a Master Reset. Creative Zen Hybrid Pro’s LED Indicator will flash red during the process. All saved settings such as customized EQs, Lighting, and Bluetooth data will be removed after completion.

CREATIVE APP

Set up your product, personalize audio settings, enhance your product’s performance, and more with the Creative app.

• Adjust noise control level for both Ambient mode and Active Noise Cancellation mode
• Experience professionally-tuned audio presets for movies, music, and games
• Customize RGB LED rings or manually turn them off
• Perform software upgrades, product registration, and more

Download the Creative app from:

iOS App Store

Google Play Store

UNICAST AND BROADCAST MODES

AVAILABLE FOR ZEN HYBRID PRO CLASSIC AND ZEN HYBRID PRO SXFI BUNDLES ONLY

UNICAST MODE

Unicast mode lets the user wirelessly connect to a compatible LE audio receiver to enjoy high-definition audio streaming on a one-to-one basis. Visit creative.com for more information on products supporting Unicast mode.

BROADCAST MODE

Broadcast mode lets the user broadcast wireless audio from an audio source to an unlimited number of supported audio devices. The LED indicator will start flashing white to indicate that it is currently broadcasting.

Note that the broadcast stream is unencrypted and any support device can join the stream if it is within range. Visit creative.com for more information on products supporting Broadcast mode

For more details on how to operate the device, refer to the device’s quick start guide included in the box.

ULTRA-LOW LATENCY (ULL) MODE

Creative BT-L3 and Creative BT-L4 offer Ultra-low Latency mode for a smooth, lag-free, and consistent viewing experience, great for time-sensitive media such as movies and games. Visit creative.com for more information on products supporting ULL mode.

TECHNICAL SPECIFICATIONS

• Headphone Drivers
  • Custom-tuned 40 mm Titanium Driver x 2
• Frequency Response
  • 20–20,000 Hz
• Sensitivity (1 kHz / mW)
  • 117 dB
• Built-in Microphones
  • Omni-directional x 5
• Bluetooth Version
  • Bluetooth 5.3
• LE Audio Modes
  • Unicast (CIS) Mode
  • Broadcast (BIS) Mode
• Classic Bluetooth Profiles
  • A2DP (Advanced Audio Distribution Profile)
  • AVRCP (Audio / Video Remote Control Profile)
  • HFP (Hands-free Profile)
• Supported Audio Codecs
  • LC3+ (ULL)
  • LC3
  • AAC
  • SBC
• Wireless Operating Frequency
  • 2402–2480 MHz
• Wireless Operating Range
  • Up to 15m / 49.2 ft, measured in open space.
• Walls and structures may affect range of device
• Battery
  • Rechargeable Lithium-ion Polymer Battery 3.7V 850 mAh
• Total Playtime^
  • Up to 100 Hours (With ANC disabled)
  • Up to 80 Hours (With ANC enabled)
• Operating Temperature
  • 0–45°C
• Headphone Weight
  • 282g / 9.95 oz
• Input rating
  • 5V 1A
• Maximum RF Output Power
  • 8 dBm

^Based on moderate volume level when streaming in Bluetooth LE Audio mode with LED turned off. Actual battery life will vary with use, settings, songs, and environmental conditions

PRODUCT REGISTRATION AND WARRANTY

Registering your product ensures you receive the most appropriate service and product support available. You can register your product at creative.com/register. Please note that your warranty rights are not dependent on registration.

Creative warrants the included Creative-branded hardware product (the “Product”) against defects in materials and workmanship (“Defect(s)”) for twelve (12) months (for the European Union, twenty-four (24) months (excluding all wear and tear), subject to certain exceptions as stated in the EU Directive 1999/44/EC) from the date of purchase. The Creative Limited Hardware Warranty (the “Warranty”) does not cover (but not limited to) consumable parts, such as batteries or protective coatings that, due to their nature, tend to diminish over time; normal wear and tear, accidents or misuse. You must provide Creative proof of original purchase of the Product by a dated itemized receipt to be eligible for the Warranty. If a Defect arises and a valid claim is received during the applicable Warranty Period, Creative will at its sole option, service the Product at no charge using new or refurbished replacement parts at our sole discretion. Warranty benefits are in addition to rights provided under local consumer laws.

For Australia only: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the goods.

• Address: Creative Technology Ltd, 31 International Business Park, #03-01, Singapore e 609921.
• Telephone: +65 6895 4101 (standard international call charges apply.)]

For the full terms and detailed information on the Warranty, please visit creative.com/compliance/zenhybridpro, or scan the QR code. A printed copy is available upon request to Creative Labs, Inc., 1900 McCarthy Boulevard, Suite 103, Milpitas, CA 95035

Important Safety Instructions. Do not listen to audio on your earphones or headphones at high volume for prolonged periods of time as hearing loss may result.

Waste Electrical and Electronic Equipment (WEEE) Symbol

The use of the WEEE Symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly, you will help protect the environment. For more detailed information about the recycling of this product, please contact your local authority, your household waste disposal service provider or the shop where you purchased the product.

BATTERIES DIRECTIVE

FOR REMOVABLE BATTERY (Li-ion/polymer, button/coin cells, cylindrical cells)

This product contains one or more of the above removable batteries. The crossed-out wheeled bin symbol indicates that the battery in this product should not be treated as unsorted municipal waste upon reaching its end of life. Instead, it should be taken to separate collection and recycling schemes. Batteries containing heavy metal content will have a two-letter symbol for the chemical under the crossed-out wheeled bin symbol. ‘Cd’ stands for cadmium, ‘Pb’ for lead, and ‘Hg’ for mercury. You can help the environment and avoid public health hazards by recycling the battery at an authorized recycling facility or the place of purchase. To find the nearest authorized recycling centre contact your local authority. Instructions for removing the battery can be found in the product user manual. The instructions should be followed carefully before attempting to remove the battery.

FOR INTEGRATED BATTERY

This product contains a Lithium-ion/polymer battery that should only be removed by an authorized recycling center. By recycling this product at your local authorized recycling center or the place of purchase, the battery will be removed and recycled separately.

OTHER INFORMATION

• Please visit creative.com/compliance/zenhybridpro for the user guide, safety and regulatory information and battery removal instructions, which is meant strictly for independently qualified professionals.
• Please visit creative.com/support/zenhybridpro for all other support related to your product

References

• Creative Labs (United States) | Sound Blaster Sound Cards, Super X-Fi, Speakers and Soundbars, Webcams, Headphones and Gaming Headsets
• Creative Worldwide SupportCreative Zen Hybrid Pro
• Creative Technology - Online Product Registration
• Creative Worldwide Support
• Creative Worldwide Support - Creative Zen Hybrid
• Creative Worldwide Support
• Creative Technology - Declaration of Conformity

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>