OPT7 Redline Easy Connect Harness Instruction Manual
- May 15, 2024
- REDLINE
Table of Contents
REDLINE
EASY CONNECT
EXPANSION
ADAPTER
FOR FORD F150 ALL MODELS 2015-2020 WITH BLIS/BACKUP CAMERA/ASSIST SENSOR
Hello Fellow OPT7-ites, Introducing the Redline Easy Connect Harness to Flat
4-Pin Extension Adapter Harness
OPT7 Redline Easy Connect Harness
Installation
Open up your tailgate first.
Next, locate the two bolts that lock the tail light (See Figure 1) and loosen
them.
Slowly move the loose tail light until it is completely removed(See Figure 2).
Important
There are two plastic clips on the inside of the tail light for fixing, please
be careful not to break it when removing it.
Locate the OEM wiring harness (See Figure 3) and unplug it from the tail light assembly by lightly pressing the Release-Latch on the connector.
HOW TO CONNECT PNP EXPANSION ADAPTER TO YOUR TAILLIGHTS
Step 4
To make it easier for you to identify the signal location represented by the
Connector/Wiring. Please read the relevant wiring instructions carefully
before commencing any work.(See Figure 4)
Next, grab the Redline Easy Connect Expansion Adapter Harness and Plug it into
the vehicle’s OEM wiring harness. Plug the other end into the tail light
connector (See Figure 5).
Route the Redline Easy Connect Expansion Adapter Harness from the left tail
light opening to the right tail light opening, then repeat the same steps for
the other side.
Step 6
Use some zip ties to secure the flat 4PIN trailer connector and reverse
wire in place along the inner bumper.
Step 7
Finally, connect the available tailgate light bar to the 4PIN trailer
connector and reverse wire for full functionality testing
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.