REDLINE PARLUX 2016-2023 Tacoma Triple Tailgate Light Bar Installation Guide
- June 13, 2024
- REDLINE PARLUX
Table of Contents
REDLINE PARLUX 2016-2023 Tacoma Triple Tailgate Light Bar
WHAT’S INCLUDED
INSTALLATION
STEP1
Before mounting the Redline Light Bar, perform a bench test by connecting the
Redline LED Light Bar to the vehicle. Ensure all the lighting functions work.
RECOMMENDATION: For a successful install, we encourage you to carefully
remove the truck’s tailgate from the vehicle to achieve the best results.
STEP2
Once you have removed the tailgate, prep the area by taking a washcloth to
remove any dirt and debris from the area. Next, use the Adhesive Promoter and
apply in the area where you will be mounting the light bar.
STEP3
Position the Redline Light Bar according to your preference, with the center
hatch as a reference point for measurement. For accurate sequential alignment
of the light bar, ensure that the OPT7 logos on each end of the vehicle are
oriented correctly.
STEP4
Utilize the EVA and Plastic Aligner to achieve a parallel and horizontal
alignment of the LED bars. The EVA will need to be temporarily inserted into
the middle gap hitch.
STEP5
Take the Plastic Aligner and connect it to the LED bar to level the light bar
for the left side of the vehicle. Next, repeat this step for the right side of
the vehicle. Gently remove the adhesive backing from each LED light bar.
Ensure both LED light bars are mounted at the same level.
STEP4
For an optimal installation of the Redline LED Bar, carefully plan and mark
the desired bracket mounting locations, taking placement into consideration to
ensure a straight application.
STEP5
Securely mount the Redline LED Bar to your vehicle using the provided screws
and clips to ensure a solid installation.
STEP6
OPTION 1: You may plug the 4-pin flat connector into the proper receptacle
on the vehicle.
OPTION 2: For a neater installation while retaining the ability to use
your trailer plug, consider utiliing the OPT7 Redline Dual 7-Pin Splitter to
4-Foot 4-Pin Extension Adapter Harness is available on our website.
Dual 7-Pin Splitter to 4 Foot 4-Pin
Please note that this item is not included and needs to be purchased
separately.
STEP7 WHERE TO CONNECT THE REVERSE SIGNAL?
Splice the white wire from the Redline Light Bar into the reverse factory tail
lights using the provided Scotch-lok wiring connector. Refer to your owner’s
manual to identify the appropriate color to tap into
for the OEM reverse wire.
STEP8
Re-test the functionality of the Redline Parlux Tacoma LED Light Bar. Ensure
all the functions are working.
Dual 7-Pin Splitter to 4 Foot 4-Pin
HARDWIRING
If hard-wiring, use the image below to identify wire color functions and pair
them to appropriately identified wires on the vehicle.
DISCLAIMER
OPT7 Lighting is not liable for damages, injuries, or death while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
YEAR 2 WARRANTY
Documents / Resources
|
REDLINE PARLUX 2016-2023 Tacoma Triple Tailgate Light
Bar
[pdf] Installation Guide
2016-2023 Tacoma, 2016-2023 Tacoma Triple Tailgate Light Bar, Triple Tailgate
Light Bar, Tailgate Light Bar, Light Bar, Bar
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>