FLYINGVOICE i1X Indoor and Outdoor Installation Guide

FLYINGVOICE i1X Indoor and Outdoor

Packing list

Physical specification

Device Installation

Installation Steps of i1X

1. Use the hexagonal wrench included with the product to remove the screws of the front panel and separate the front panel from the bottom shell.
2. Drill the installation holes on the wall according to the installation dimensions drawing included with the product.
3. Use the expansion tubes and screws included with the product to fix the bottom shell on the wall, if the wall has been reserved for the network cable hole, the network cable should be put through the reserved hole on the back of the bottom shell in this step.
4. Install the front panel to the bottom shell and tighten the fixing screws of front panel.

Power Supply and Connection

1. If use PoE power supply, just connect the RJ45 cable through the reserved hole on the back or the reserved hole below according to your environment to provide power and network.
2. If use 12V DC power supply, connect the power connector +12V and GND.
3. If access control function is needed, connect all the component according to the schematic on the next page.

Note : If the switch is without electricity, please set short circuit with IN- and GND, connect the switch to 12V and IN+.

Configuration

1. Configuring your device
   

   • Check if the device enables Internet with the Ethernet cable.
   • By default, the device will obtain an IP address by itself. Long press any button for 5 seconds, the device will report the IP address, you can log in the web interface on your phone or computer in the same LAN by this IP address.
   • If it is in the mode of static IP address, open the cover of the device, tap the reset button to enable Wi-Fi. Connect Wi-Fi of the device, and access into web interface by typing 192.168.15.1 on the website to configure your static IP address.
   • The default user name and password are both admin. If the device is used in access door controller, we recommend you to modify your name and password timely.

2. Phone registration

   • Log in web interface and head to configure information, click the “Sip-Account 1“, choose Enable on Line Enable and input SIP account parameters.
     Configure information

3. Intercom configuration
   Click “Device-Function Key” to set speed dial parameters, and input an extension number in column “Value 1”.

4. Security function configuration
   Click “Device-Function Key” to set the Action Url parameters, and input the corresponding address of the door number in column “Value 1”.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>