HOOKE ROAD BXG.2038A-1S Wrangler JK Mad Max Front Bumper Grill Instruction Manual

Regular Version

If you purchased the wing version, you will receive the following accessories in another package.

Tools required:

a. 19mm socket wrench;
b.19mm wrench;
c. 10mm L type wrench;

Installation time:

About 2 hours, 2-3 people may be needed. Installation time may differ according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.2038A-1S & BXG.2038B-S), please scan the QR code.

Installation instruction:

Step 1: Install the Socket Head Cap Bolts (M1235), Split Lock Washer (D12), Flat Washer (M1235*2), Flange Hex Lock Nuts (M12). No need to tighten it in this step.

Step 2:
After step 1, install the Wrench Bracket on it. As shown below. And tighten the Socket Head Cap Bolts (M12*35) in this step with 10mm L type wrench.

Step 3:
Install the Mountings Bracket into the bumper with the Button Head Socket Cap Bolts Screws (M820), Split Lock Washer (D8), Flat Washer (M820*1), Flange Hex Lock Nuts (M8). Don’t tighten up those bolts.

Step 4:
Install the Button Head Socket Cap Bolts Screws (M620), Split Lock Washer (D6, Flat Washer (M620*1). Hook up the bumper into your vehicle.

Step 5:
Before install the bumper, please glue the glue strip into the bumper.
Install the bumper & the D-rings base into the car frame with the Hex Bolt(M1240), Split Lock Washer (D12), Flat Washer (M122*30), Flange Hex Lock Nuts (M12). Note: Before installing those bolts, please adjust the position of the mounting bracket installed in the previous step and hang it on your vehicle.

Step 6:
Install the D-rings.

Step 7:
The installation is complete (without the wings part). We hope you enjoy a wonderful off-road life with this quality Hooke Road product!

Step 8:
If you purchased the wings version, please refer to the below steps to install the wings. Install the wings with the Button Head Socket Cap Bolts Screws (M820 & M616), Split Lock Washer (D8 & D6), Flat Washer (M8161 & M6161), Flange Hex Lock Nuts (M8 & M6) .

Step 9:
The installation is complete. We hope you enjoy a wonderful off road life with this quality product!

Step 10:
This step is optional and not 100% necessary. IF you purchase the wing version, you can connect the wing light as follow.

Installation: Find the factory fender flares light wiring harness. Connect the wiring harness as follows.
Negative Electrode (Black Wire) – Factory Black Wire
DRL Wire (Red Wire)- Factory White Green Wire Turn Lamp (Yellow Wire)-Factory White Yellow Wire
Notes: Different models may have different wiring harness colors, but the above wiring methods are the same.

Attention :

1. The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
2. Please feel free to contact your distributor if you have any kind of question about your purchase.

Hooke Road to find your parts

FACEBOOK

INSTRAGRAM

Post Your Jeep/Truck w/Hashtag

hookeroad to Win Discount Every Week

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>