MARTEC Lighting TLZD3459WDS Zone 9W PIR Motion Sensor Tricolour LED Downlight Instruction Manual
- June 10, 2024
- MARTEC Lighting
Table of Contents
TLZD3459WDS Zone 9W PIR
Motion Sensor Tricolour LED Downlight
Instruction Manual
TLZD3459WDS Zone 9W PIR Motion Sensor Tricolour LED Downlight
Martec Pty Ltd
6 Austool PI 1 Ingleburn, NSW 2565
P: 02 8778 7500
F: 02 8778 7555
E: sales@martecltd.com.au
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION. PLEASE RETAIN
INSTRUCTIONS FOR FUTURE REFERENCE.
FITTING MUST BE INSTALLED BY A QUALIFIED ELECTRICAL CONTRACTOR 
INSTALLATION
- This unit must be installed and wired by a qualified electrical contractor
- Ensure power is off at mains before wiring and installation
- For maximum number per circuit breaker, use the recommended quantities as for a standard mains SOW lamp (or 100W R80)
- Ensure that the area that the unit is to be fitted has a minimum height clearance of 50mm.
- Cut a 90mm hole in the ceiling for each unit ensuring no positions are under joists, cables, pipes etc.
- Select desired Colour Temperature (3000K, 4000K or 5000K) by toggling the switch the back of the down-light.
- Insert the power cable plug into the power socket located in the ceiling.
- Feed springs through the ceiling hole slowly releasing the unit up to the ceiling. The springs will hold the fitting in place.
- For indoor use only.Ta = 25°C
- Turn the power on
INSTRUCTIONS:
Cut out ( size:90mm) hole in the ceiling. Ensure there is sufficient clearance
in the area where you will position the fitting.
Select the colour preference by sliding the dip switch on rear of down light.
(3000K, 4000K, 5000K) Connect fitting to the mains power via power plug.
The sensor has increased sensitivity with movement across the detection area
(Figure 1A)
The sensor has reduced sensitivity with movement towards and away from the
detection area (Figure 1B)
INSULATION
Thermal insulation clearance class IC-4 covered; meaning that the Zone LED
downlight can be covered entirely by insulation abutting or is within 100mm
horizontally of the luminaire.
| DIMENSION ( FOR DRIVER) | CLEARANCE |
|---|---|
| SC -Side clearance to thermal insulation and building element. | 25mm |
| HC – Height clearance to thermal insulation and building element. | 50mm |
IMPORTANT NOTE
This fixture must not be installed with loose fill insulation (as defined in
NZS 4246) such as macerated paper and wool.
This Downlight has achieved an IC-F IC-4 insulation rating in accordance with
AS/NZS 60598.2.2
PIR Sensor Features
Sensor detection range: 4m max. (atmount ng height 2.5m) Sensor detection
angle: 360°
On time: 1 minute (Subsequent detect on will restart the on time)
Daylight
Sensor Instructions:
The maximum detection height for the sensor is 2.8m (Figure 2).
The sensor is not suitable to use with dimmer switches and should not be used
with a circuit which has a dimmer.
Aust/NZ Approval No. SAA-10479
www.martecaustralia.com.au
02 8778 7500
sales@martecltd.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>