FIELDMANN FZH 5020 Garden Hoses User Manual
- May 15, 2024
- FIELDMANN
Table of Contents
FZH 5020 Garden Hoses
User Manual
FZH 5020
FZH 5020 Garden Hoses
USER’S MANUAL
Thank you for purchasing this solar shower.
Before you start using it, please read this user manual carefully and save it
for future use.
DESCRIPTION OF THE PRODUCT
| NO | Description | QTY |
|---|---|---|
| 1 | Shower head | 1 |
| 2 | Handle | 1 |
| 3 | Hose Connecting | 1 |
| 4 | Teflon | 1 |
| 5 | Setscrew | 4 |
| 6 | Drain Screw | 1 |
INSTALLATION
In order to use our products properly and get the most satisfaction and pleasure, please pay attention to the following details.
- The solar shower must be installed on solid ground (concrete floor) or concrete base to make sure its stabilization and safety for user.
- The solar shower is equipped with base plate, which has 4 prefabricated holes for screws installation on solid ground or portable base.
- For easy installation, please separately buy our portable base. Just screw the solar with the base and you could enjoy the warm water.
- Please install the solar shower at the location where has the most sunshine.
- Please connect inlet of the solar shower to tap water system of your home. It is better to have the inlet of solar shower connected to your garden tap then to the tap water system.
- Please pay attention that it is necessary to have a tap installed before the inlet of solar shower.
- To prevent the scalding from the hot water, extra attention to the following.
Before turn on the solar shower, please make sure the valve is at the cold water position (blue), then turn on the valve and gradually adjust the water toward the hot water position (red), until reach the most comfortable temperature.
Warning! Under the exposure of the very strong sun radiations, the water temperature coming from the solar shower may reach 60 ˚C or 140 ˚F.
NOTE: Portable base is not included in the shower, please buy separately
INITIAL SET UP OF THE SHOWER
-
Turn and lift shower handle to FULL ON HOT position.
-
Tighten the bottom drain screw，to make sure it is sealed and no water leaks.
-
Turn on water supply to garden hose to fill shower. Shower will take about 2~4 minutes to fill.
NOTE: Filling tube with valve in hot position ensures no air pockets are trapped in shower. This procedure is used for initial set up only. -
When water flows from shower head, turn shower handle off. Turning the shower off allows the water to begin heating.
-
Shower is ready to absorb sunlight and heat your water.
NOTE: Depending on available sunlight and outside temperature, it may take up 3 hours or longer to fully heat the water. Using the shower too soon will yield less heated water. A recently used shower (that has not been emptied) will take less time as it will have retained some hot water. -
Simply lift the handle to its ON position and you are ready to enjoy your sun-warmed water!
NOTE: The faucet connected to garden hose must be turned on for shower to run. -
Turn off water supply to shower when done.
WARNING!
IF SHOWER HAS NOT BEEN USED FOR MORE THAN THREE DAYS, WE RECOMMEND RUNNING the
SHOWER FOR 2 MINUTES TO REMOVE STAGNANT WATER. STAGNANT WATER IN WARM
ENVIRONMENT CAN PROVIDE A GROWTH ENVIRONMENT FOR HAZARDOUS BACTERIA.
Remark for off-season storage protection:
- After the pool season, please clean the solar shower with soft cloth.
- Please close the garden tap which is connected to the inlet of solar shower. And please make the cold and hot water valve in “OPEN” position, then unscrew the bottom drain,to make sure that all water in solar shower can be fully drained out.
- While the solar shower is under the dry and frozen environment, the cold and hot water valve should be in “OPEN” position. The damage caused by frozen temperature will not be covered by our warranty.
WARNING!
-
The damage caused by using mud water, salt water or frozen temperature will not be covered by our warranty.
-
Wipe shower off after use.
-
DO NOT use the solar shower with base in high wind conditions. Wind may cause the shower to become unstable and fall over hurting you, children or property.
THIS IS NOT a recreational device. DO NOT climb on, hang from solar shower or stand on base. Use only as intended. -
Keep small parts, hardware and plastic bags out of the reach of children.
Model
Warranty Certificate
Serial No
Dealer’s stamp
Date of purchase
Conditions of guarantee
This product is warranted for the period of 24 mon ths from the date of
purchase to the end-user. Warranty is limited to the following conditions.
Warranty is referred only to the customer goods using for common domestic use.
The claim forservi ce can be applied either at dealeťs shop where the product
was bought, or at below mentioned autho rized service shops. The end-user is
obligated to set up a claim immediately when the defects appeared but only
till the end of warranty period. The end -user is obligated to cooperate to
certify the clai ming defects. Only completed and clean (according to
hygienic standards) product will be accepted. ln case of eligible warranty
claim the warranty peri od will be prolonged by the period from the date of
claim application till the date of taking overthe pro duet by end-user, or
the date the end-user is obliga ted to take it over. To obtain the service
under this warranty, end-user is obligated to certify his claim with duly
completed following documents: receipt, certificate of warranty, certificate
of installation …
This warranty is void especially if apply as follows:
- Defects which were put on sale.
- Wear-out or damage caused by common use.
- The product was damaged by unprofessional or wrong installation, used in contrary to the appli cable instruction manual, used in contrary to legal enactment and common process of use or used for another purpose which has been designed for.
- The productwas damaged by uncared-foror insufficient maintenance.
- The product was damaged by dirt, accident of force majeure (natural disaster, fire, flo od, … ).
- Defects on functionality caused by low duality of signal, electromagnetic field interference etc.
- The product was mechanically damaged (e.g. broken button, fall. .. ).
- Damage caused by use of unsuitable media, fillings, expendable supplies (ba tteries) or by unsuitable working conditions (e.g. high temperatures, high humidity, quakes, … ).
- Repair, modification or other failure action to the product by unauthorized person.
- End-user did not prove enough his right to claim (time and place of purchase).
- Data on presented documents differs from data on products.
- Cases when the claiming product can not be indentified according to the pre sented documents (e.g. the serial number or the warranty seal has been damaged).
Authorized service centres
Fast Paland, Sp. z o.o. Ul.
Kwietniowa 36
05-090 Wypęędy Paland
Tel.: +48 697 690 228
Mail: serwis@fastpoland.pl
www.fastpoland.pl