ROBENS 187456 Cylinder Bush Saw Instruction Manual
- May 15, 2024
- ROBENS
Table of Contents
ROBENS 187456 Cylinder Bush Saw
Specifications
Product Name: Cylinder Bush Saw
- Blades: Two included (for fresh wood and dry wood)
Product Usage Instructions
Assembly
- Follow the steps provided in the user manual to assemble the Robens Cylinder Bush Saw.
Disassembly
- Refer to the user manual for step-by-step instructions on disassembling the bush saw.
Blade Usage
- For Fresh Wood: [Provide specific instructions for using the blade designed for fresh wood.]
- For Dry Wood: [Provide specific instructions for using the blade designed for dry wood.]
Safety Instructions
- Always exercise caution when using the saw.
- Before cutting, create a slit (kerf) by drawing the saw towards you 5-8 times to facilitate a straight cut.
- Regularly check the blade’s sharpness to prevent accidents and ensure efficient cutting.
Assemble
Disassemble
Two blades included (for fresh wood and dry wood)
SAW SAFETY INSTRUCTIONS
Always take care when using a saw:
- You should see only in timber that is wider than your wrist. When you start to saw, carefully draw the saw towards you 5-8 times to make a slit (called a kerf). This makes it easier for you to cut straight.
- Never leave a saw lying on the ground.
- Protect the saw blade when not in use.
- Always clean your saw after use. A wet and dirty saw will rust and become blunt.
- Do not leave your saw unattended. Store out of the reach of children
FAQ
- Q: How do I maintain the blades of the Cylinder Bush Saw?
- A: To maintain the blades, regularly clean them after use, keep them dry to prevent rust, and store them in a safe place away from moisture.
- Q: Can I use the saw for cutting metal or other materials?
- A: The Cylinder Bush Saw is specifically designed for cutting wood. Do not use it for cutting metal or other materials to avoid damage to the blades.
© 11/2023 Oase Outdoors ApS. EU: Kornvej 9, DK-7323 Give. UK: One Glass Wharf, Bristol, BS2 0ZX
Read User Manual Online (PDF format)
Loading......