ROBENS 690166 Lighthouse Rechargeable Instruction Manual
- June 4, 2024
- ROBENS
Table of Contents
ROBENS 690166 Lighthouse Rechargeable
INSTRUCTIONS FOR USE
- Hanger
- Removeable lampshade
- Hook
- Button and power indicator
- USB power output
- Micro USB power input
LIGHT MODES
- Press the button for warm light (700 Lm)
- Press the button twice for cool light (300 Lm)
- Press the button three times for warm and cool together (1000 Lm)
- Press the button four times for flashing mode
- In the first three modes, press and hold the button to dim the light
USE OF THE LAMP
- Lamp is charged using 5V DC USB power outlet. Micro USB input (6.) is located under protective lid
- Charging cable is included with the lamp
- Lamp have built in overcharge protection circuit
- When charging the power indicator lights red. When fully charged it lights green
- When power is low the indicator will light red
- Please fully charge the lamp before use
- Lamp can also be used as power bank to charge phones etc. USB output (5.) is located under protective lid
- Lamp can be used hanging from the hanger, standing, or hanging from the hook
- To remove the lampshade, rotate it counterclockwise from the body of the lamp
- Lamp can be cleaned with water and a damp rag
- Lamp is water resistant to IP44
- Do not use corrosive liquids to clean the lamp
- Do not stare into the light source
- Do not modify the product
LIGHT SOURCE: 12W LED
This product contains a light source of energy efficiency class G. Light source and control gear is not replaceable. This would introduce weak points in the construction, that could reduce the lifetime of the product.
INSTRUCTION FOR REMOVAL OF LIGHT SOURCE AND CONTROL GEAR BY MARKET
SURVEILLANCE AUTHORITIES
- Remove lamp shade by hand, rotating it counterclockwise
- Remove clear lens covering light source PCB, by using a flathead screwdriver to pry back 3 pcs tabs holding it in place
- Unscrew screws holding light source PCB in place
- Cut needed wires to remove the required components for testing
- Remove battery compartment lid, by rotating it counterclockwise
- Remove 2 pcs screws to remove the inner battery lid
- Cut wires to allow removal of battery. Dispose of battery according to local regulations
- Cut wires to allow removal of charge port electronics on circuit board. Dispose of electronics according to local regulations
- Dispose of remaining components according to local regulations
TECHNICAL DATA
- 3.7V , 12W
- Input : 5V , 1A
- Output : 5V , 1A
- Battery : 3.7V , 4000 mAh Li-Ion
- Class 3 appliance
Robens® is a reg. trademark of Oase Outdoors EU: Kornvej 9, DK-7323 Give, Denmark, UK: One Glass Wharf, Bristol, BS2 0ZX ROBENS.DE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>