brennenstuhl PL 200 AC LED Rechargeable Hand Lamp Instruction Manual
- June 17, 2024
- brennenstuhl
Table of Contents
brennenstuhl PL 200 AC LED Rechargeable Hand Lamp
Specifications
- LED: COB
- Rechargeable battery: Li-Pol 3.7V/450mAh
- USB charging input: USB C 5V DC, internally limited to 500mA
- Charging duration: ~2 hours
- IP class: 20
- Temperature range: not specified
- EU-compliant
Product Usage Instructions
Control Elements:
- On/Off switch
- LED Front
- USB C charging socket with cover
- Charging indicator light integrated in the switch
- Magnet
- Clip
- USB charging cable/USB C
Charging:
Charge the battery using only a USB cable. Use a tested USB power source (e.g., charger, computer) with a maximum output of 5V. Connect USB power source – USB charging cable – Charging socket. The charging indicator flashes during charging and remains constant when the battery is fully charged.
Battery Maintenance:
It is recommended to charge the battery every 3 months to maintain optimal performance.
Disposal Instructions:
Do not dispose of electronic appliances, batteries, and rechargeable batteries in household waste. They are considered special waste and should be recycled in an environmentally friendly manner.
Conformity Declaration:
The Declaration of Conformity is available with the manufacturer. For additional information, visit the Service/FAQ section on the manufacturer’s website.
FAQ
- Q: How long does it take to charge the battery fully?
- A: The charging duration is approximately 2 hours.
- Q: What should I do if the charging indicator does not light up?
- A: Check the connection between the USB cable and the power source. Ensure that the power source is providing the required output voltage.
SAFETY INFORMATION
- Carefully read these operating instructions before using the device.
- Do not use the light if it is damaged – danger of death. In this case, contact an electrician or refer to the specified service address.
- Do not look directly into the light.
- Never open the device.
- Do not use the working light in potentially explosive atmospheres – risk of death!
- To charge the batteries, only use a certified USB power supply unit.
COMMISSIONING
- Before using the device for the first time, completely discharge and recharge the rechargeable battery once.
- Switch at the front: Light sequence: 100% – 40% – 10% – red – red flashing – off.
- Lamp cannot be used while charging.
- In cases of extended non-use, charge the rechargeable every 3 months.
CONTROL ELEMENTS
- On/Off switch
- LED Front
- USB C charging socket with cover
- Charging indicator light integrated in the switch
- Magnet
- Clip
- USB charging cable/USB C
CHARGING
Charge your battery using the supplied USB cable only. Exclusively use a certified USB power source (e.g. charging device, computer) with a maximum of 5 V output voltage: Connection: USB source – USB charging cable 7 – charging socket 3. During charging, the charging indicator flashes, it is illuminated constantly when the battery is fully charged
TECHNICAL DATA
- LED: COB
- Rechargeable battery: installed, Li-Pol 3.7 V/450 m Ah
- USB charging input: USB C 5 V DC, internally limited to 500 mA
- Charging duration: ~2 h
- IP class: IP 20
- Temperature range: -10 °C – +40 °C
- EU-compliant:
- UK-compliant:
Electronic appliances, batteries and rechargeable batteries must not be disposed of in household waste! Old electronic and electric devices, as well as batteries and rechargeable batteries, are special waste and need to be gathered separately and be sent for recycling in an environmentally friendly manner.
CONFORMITY DECLARATION
The Declaration of Conformity is filed with the manufacturer. For further information, please refer to the Service/FAQ section on our homepage www.brennenstuhl.com