Ciro G0066051 Rear Tie Down Brackets Installation Guide
- June 17, 2024
- Ciro
Table of Contents
Ciro G0066051 Rear Tie Down Brackets
rear tie-down brackets for Harley Davidson touring models
WARNING
This indication alerts you to the fact that ignoring the contents described
herein can result in potentially serious injury or death if not followed.
CAUTION
This indication alerts you to the fact that ignoring the contents described
herein can or will result in material damage and/or personal injury.
ATTENTION
This indication alerts you to the fact if you ignore this detail you will
affect the performance or functionality of the product.
All Ciro products are designed for “easy assembly” and/or “plug and play”. We recommend a competent mechanic install our products, using standard mechanical procedures to ensure a safe and successful installation. Read completely and understand the instructions before starting installation.
NOTE: Ciro products are designed and manufactured under very strict quality control. Ciro warrants that products sold to the original purchaser shall be free from any defects in materials and workmanship for 3 (three) years from the date of purchase, and a limited lifetime warranty against LED failure. Ciro will have no obligation if the customer cannot show proof of purchase. Warranty will not be granted unless the part is properly installed, unmodified, and maintained. Ciro will not be liable for any consequential and incidental damages, including labor, or non-Ciro products. Please visit Ciro3d.com for our complete warranty policy.
Included Items
- 2 – Rear tie down brackets for Harley Davidson touring models
- 1 – Hardware kit
Installation Instructions
- Park on a level surface and shut off the motorcycle. Ensure that the engine has time to cool before installation.
- Remove the top and bottom screws using a 5/16″ Allen wrench for the top and 1/4″ for the bottom. These screws will be replaced with included screws in the hardware kit, Fig, 1.
- With the floorboard removed Fig. 2 shows there are three optional positions for the top screw depending on desired height of the floorboard. The bottom hole is only for the bottom screw shown in Fig.3.
- Place the lock washer on the top screw and the collar on the bottom screw as in Fig.3.
- Place the bottom screw through the floorboard mount and through the down bracket. Decide desired height for the floorboard mount position and insert the top screw through the floorboard mount and tie down the bracket. Fig. 4 shows the highest mount position.
- With both screws finger tight, torque to these specs, Top screw, 49-56 N-m, (36-42 ft-lbs). Bottom screw, 5-8 N-m, (48-72 in-lbs).
- Repeat steps 2-6 on the other side of the motorcycle.
NOTE
- Ciro Tie Down Brackets are designed to assist you when working to stabilize a Harley Davidson Touring motorcycle.
- The person doing the job is responsible for the safety and security of the motorcycle.
- Ciro Tie Down Brackets are not designed to be the only device used when stabilizing your Harley Davidson.
- They should be used in combination with a front wheel chock and front tie-down straps.
TIPS FOR USING THE CIRO TIE-DOWN BRACKETS
- Use high-quality tie-down straps that are in good condition. Read and understand their load ratings.
- Use tie-down straps that are correct for the job. Cam or ratchet are both acceptable.
- Secure the front wheel straight ahead and prevent forward movement. A wheelchock can be helpful.
- Do not overtighten the straps. The rear suspension should compress no more than one inch.
G0066051, REV. For the latest version of installation instructions visit www.ciro3d.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>