superbrightleds BYR-FS-RGBDIG-5050-30-5M RGB Addressable LED Strip Light Kit 16.4ft User Manual
- June 17, 2024
- superbrightleds
Table of Contents
User Manual
BYR-FS-RGBDIG-5050-30-5M
BYR-FS-RGBDIG-5050-30-5M RGB Addressable LED Strip Light Kit 16.4ft
Important: Read all instructions prior to installation.
Addressable RGB LED Strip Kit
Safety and Notes
- Do not connect controller or strip directly to 120 VAC power; use the included power adapter only.
- Make sure the power supply is not plugged in before connecting or disconnecting any of the systems components.
- Do not expose the power supply to direct or indirect moisture.
This kit may be used in wet environments where the power supply and its barrel connector are fully shielded from moisture.
Installation
-
Remove strip from reel and install on a dry, clean surface using the adhesive rear backing.
Note: Make certain the IR sensor mounted in the strip is not obstructed. -
Connect to power adapter.
-
Plug power adapter into wall outlet.
Note: Use a protected GFCI receptacle if the strip itself is being installed in a damp or wet location. -
Use remote to change settings.
IR Remote
| Play / Pause
---|---
| On / Of
| Brightness + (in static mode)
speed +(in dynamic mode)
| Brightness – (in static mode)
speed -(in dynamic mode)
| single color
| Increase red, green, blue
| Decrease red, green, blue
| DIY Color instructions: press either DIY key. Adjust color using increase /
decrease color keys, press the DIY color key choosen again. Your setting is
saved.
---|---
| Open / closing
| Trail to the left / to the right
| Riding left / right
| Flowing left / right
| Trailing left / right
| Flash, jump
| Dynamic multi color stream, meteor color effect
| Rolling color effect, automatic cycle
Remote must be aimed at the base of the strip where the built-in controller is located.
Rev Date: V2 06/16/2023
4400 Earth City Expy, St. Louis, MO
63045 866-590-3533
superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>