luminii LLRGBW36-XX LineLED Dynamic Color LED Strip Installation Guide
- June 17, 2024
- luminii
Table of Contents
****
luminii LLRGBW36-XX LineLED Dynamic Color LED Strip
Specifications
- Model : LLRGBW36-XX
- Power : 24V
- Certifications: UL STD 2108, CSA STD NO. 250.0
- Location Use : Suitable for damp locations
Product Usage Instructions
Installation
The product should be installed by a qualified electrician.
Ensure power is off at the fuse box before installation to prevent electrical shock. Use only with a Class 2 power unit.
Pre-Installation Testing
Before installing, always test the LLRGBW36 by connecting it to the power supply to ensure it is working properly and undamaged.
Installation Steps
- Clean the area thoroughly where the tape will be installed.
- If installing on a rough surface, apply a layer of Aluminum tape or similar material before tape application.
- Remove the paper backing from the LLRGBW36 and firmly press down, ensuring no air bubbles that can cause surface irregularities.
- Avoid bending the LLRGBW36 in sharp horizontal angles to prevent damage to the LEDs.
Wiring Connections
Follow RGBW controller and receiver instructions for all wiring connections. Cut the LLRGBW36 strip between two rows of solder pads if required for installation, always cut from the end without connector/wire leads.
FAQ
- Q: Can I install the LineLED 24V in a wet location?
- A : No, the product is suitable for damp locations only.
- Q: What should I do if I notice surface irregularities after installation?
- A : Ensure there are no air bubbles during installation to prevent surface irregularities. If noticed, gently reapply pressure to remove them.
Please read all instructions prior to installation and keep them for future reference!
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT THE FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONS
- FOR UNDER CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD NO. 250.0.
ATTENTION : ALWAYS TEST LLRGBW36 BEFORE INSTALLING. CONNECT LLRGBW36 TO THE POWER SUPPLY TO ENSURE IT IS WORKING PROPERLY AND NO DAMAGE HAS OCCURRED DURING SHIPPING.
Installation Instructions
- Clean the area thoroughly where the tape will be installed.
- For rough surface installations, it is recommended to apply a layer of Aluminum tape or similar material prior to tape application
- Clean the area thoroughly where the tape will be installed.
- For rough surface installations, it is recommended to apply a layer of Aluminum tape or similar material prior to tape application
- If required for installation, cut the LLRGBW36 strip between two rows of solder pads.
- Always cut LLRGBW36 from the end without connector/wire leads.
- Follow RGBW controller and receiver instructions for all wiring connections.
- Refer to the diagram for needed components.
LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
CONTACTS
- 7777 Merrimac Ave Niles, IL 60714
- T 224.333.6033
- F 224.757.7557
- info@luminii.com
- www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>