ApplyLabWork S100 DLP Modeling Instructions
- June 4, 2024
- APPLYLABWORK
Table of Contents
D75, S100, Pro95, & Pro55
DLP Modeling – Clear
(DMD-R001CR)
APPLYLABWORK PRINTING TIPS
Check:
- UV optical pathways are clean
- The resin tank is free of defect
- Resin is well shaken
RayWare: [MoonRay Pinter]
Open RayWare software(version 2.8.1 and later) and connect to the printer.
Print Setup:
Select printer model
Material： SprintRay standard clear
Layer Thickness：50/100 µm
- When printing arches directly on the build platform, vertically or horizontally supports are not needed.
- For detailed calibration for resin can refer to Dimension and Tolerance.
Washing:
IPA 95%, maximum for up to 5 minutes, gently shake off / blow off excess IPA
quickly, and set print in a shaded airy place to dry completely before curing.
Extended time in IPA causes deformation. The dried print might be a little
tacky to the touch.
Post-curing:
Pro-Cure: (firmware version 1.51 and later)
Select Custom, and then select the condition as30°C for 10 min.
Form Cure:
Select Custom Profile, and then select the condition as 60°C for 15 min.
Other:
Heat prints to 60°C, depending on the size, adjust time accordingly (15~40
mins). Move the warm print to the UV-curing chamber for 40 seconds. A yellow
tint may appear after UV curing but will subside in a few days
Storage:
DO NOT keep the resin in the tank for more than 3 days. Filter out all debris
in the case of failed print jobs
Design Concept Series
Documents / Resources
|
ApplyLabWork S100 DLP
Modeling
[pdf] Instructions
S100 DLP Modeling, S100, DLP Modeling, Modeling
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>