APPLYLABWORK MD-R001WT Form 2 and 3 Printer Laser Modeling Instructions
- June 3, 2024
- APPLYLABWORK
Table of Contents
APPLYLABWORK MD-R001WT Form 2 and 3 Printer Laser Modeling
Check:
- UV optical pathways are clean
- Vat is free of defect
- Resin is well shakened
Open-Mode
(Form2): Printer at idle
- Tap the touchscreen “Printer” icon, open the “Settings” menu
- Select Open Mode
- Select On
Cartridege
(Form2 & 3):
Refill the corresponding cartridge e.g.FormLabs Grey version 4 cartridge. Open air vent, turn the cartridge upside down, drip dry through air vent for 10 mins to avoid cross-contamination, refill, shake well for 2 mins, insert & print (may work up to 2 refills before locked by FL software).
Warning: Cross-contamination of resins could cause size inaccuracy or
wavy line.
Alternative Solution: North America, Other Regions
PreForm Setting
- Select Printer: Form 2 or Form 3
- Material: Resin: Grey; Version: V4
- Suggest Layer Thickness 100~25
Washing
- IPA 95%, maximum for up to 5 minutes, gently shake off / blow-off excess IPA quickly, set print in a shaded airy place to dry completely before curing.
- Extended time in IPA causes deformation.
- The dried print might be a little tacky to the touch.
Post-curing:
For optimal material performance, the condition of FormCure is 60℃ / 60 mins.
Storage
- Keep resin away from heat & light.
- NOT accessible to children.
- Filter used resins before storage.
Note:
- Keep print environment well-ventilated.
- Avoid direct contact to skin or eyes. Rinse cautiously with water/soap and water for several minutes if in contact to eyes/skin.
- Wear chemically-resistant gloves like nitrile or neoprene (not latex) when handling.
- DO NOT pour uncured resin down the drain. Abandoned resin can be cured by sunlight before discarding.
WARNING:
Contact with uncured resin may cause eye or skin irritation and allergic reaction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>