ApplyLabWork PT-EX001TN Formlabs Printers Compatible Instructions
- June 11, 2024
- APPLYLABWORK
Table of Contents
ApplyLabWork PT-EX001TN Formlabs Printers Compatible
Product Information
The ApplyLabWork Printing Instructions are designed for use with FormLabs SLA Printers Laser EXPERT Tan (PT-EX001TN). The instructions provide information on how to operate the printer in Open-Mode and Cartridge mode. The instructions also provide details on PreForm Settings, Washing, and Post- Curing the printed material.
Product Usage Instructions
- Depending on the mode you want to use, either enable Open-Mode or refill the cartridge and insert it into the printer.
- Follow the PreForm Settings according to your region and select the appropriate printer and material.
- Print your desired object.
- Wash the printed material using IPA 95% and gently shake-off or blow-off excess IPA quickly.
- Set the print in a shaded, airy place to dry completely before curing.
- Use FormCure 60 for 60 minutes to improve the material performance.
Warning: Contact may cause eye or skin irritation and allergic reaction. Cross-contamination of resins could cause size inaccuracy or wavy lines. Extended time in IPA causes deformation. Dried print might be a little tacky to touch.
APPLYLABWORK PRINTING INSTRUCTIONS
Check
- UV optical pathways are clean
- Vat is free of defect
- Resin is well shakened
Open-Mode (Form2 only)
Printer at idle
- Tap touchscreen “printer” icon, open “Settings” menu
- Select Open Mode
- Select On
Cartridge (Form2 & 3):
Refill corresponding cartridge e.g., FormLabs Grey version 4 cartridge. Open
air vent, turn cartridge upside down, drip dry through air vent for 10 mins to
avoid cross contamination, refill, shake well for 2 mins, insert & print (may
work up to 2 refills before locked by FL software)
Warning: Cross contamination of resins could cause size inaccuracy or wavy line.
- Alternative Solution: North America , Other Regions
PreForm Setting
- Select Printer: Form2, Form3 or …
- Material Select: Grey and V4
- Suggest Layer Thickness 160~25
Washing:
IPA 95%, maximum for up to 5 minutes, gently shake-off / blow-off excess IPA
quickly, set print in a shaded airy place to dry completely before curing.
Extended time in IPA causes deformation. Dried print might be a little tacky
to touch.
Post-curing (Necessary):
For optimal material performance: FormCure 60 ℃ / 60 mins. Start FormCure from
room temperature.
Storage
- Keep resin away from heat & light.
- NOT accessible to children.
- Filter used resins before storage.
Note
- Keep print environment well ventilated.
- Avoid direct contact to skin or eyes. Rinse cautiously with water / soap and water for several minutes if contact to eyes / skin.
- Wear chemically resistant gloves like nitrile or neoprene (not latex) when handling.
- DO NOT pour uncured resin down the drain. Abandoned resin can be cured by sunlight before discarding.
- Unless specifically indicated, EXPERT resin is NOT approved for use with food, drink, or on/in the human body.
WARNING: Contact may cause eye or skin irritation and allergic reaction.
Prototype Engineering Seriess
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>