Fitop 49W Pack Smart Recessed Lighting User Manual
- June 15, 2024
- FITOP
Table of Contents
Fitop 49W Pack Smart Recessed Lighting User Manual
Installation
Find out the template (for the hole size installation) back of the box, use the circle template to measure the size of holes then cut out holes
Open the box, take out accessory of wire clip.
Use suitable tool to remove one of the knockouts of the side plate
Remove one of the knockouts on the side plate. Put wires through the hole
Using wire nuts, connect wires with the same color on the box.
Holding the clips, and push the fixture into installation hole
Release spring clips and push into place.
Safety Instructions
- The product only supports 2.4Gwifi, and does not support 5G.
- When installing, disconnect the power first and then connect the lights.
- The lamps are not suitable for directly installed on the general flammable surface.
- The lamps are not suitable for covering the insulation material.
- The light source of this lamp cannot be replaced; when the light source reaches the service life, the entire lamp should be replaced.
- When the lamp is damaged or damaged, it shall not use/power-on, but it shall be handled safely.
- Lighting is limited to indoors, don’t be in wet and high temperature environment.
Set up your smart downlight
What You Need:
- A Wi-Fi router supporting the 2.4GHz and 802.11b/g/n bands. 5GHz is not supported.
- Download Fitop App from the App Store (iOS) or Google Play (Android). Log in with your account (new users need to create an account).
- Add smart downlight, please turn on WiFi and Bluetooth on your phone ortablet. For a better experience, please turn on location permissions.
Power on downlight (1s) -> Turn off (1s)->on (1s)->off (1s) -> on. The smart downlight will blink or breathe. If not, try again. Tap the “”or” Add Device ” button on the app.
Bluetooth will discover the smart downlight around. Add the downlight.
You can also add smart downlight manually by following the instructions on the
app.
Once all the downlight connections have been made, if you see the message on
the home page: 1 or more devices to be activated. This means that the
downlight has been successfully connected via Bluetooth and the WIFI
connection is inactivated. Click on the prompt to go to the next step.
Click on the top right corner to activate.
Enter the user wifi account and password and click Next.
Indicates that the downlight’s wifi connection is being activated.
When you see a✔ on the downlight icon to indicate that the wifi connection is active, click on the top right corner to finish.
At this point all the downlight wifi connections on the home page have been
activated and can support remote control, device sharing and other operations.
FAQS
If you have any questions, you can contact us through the Fitop App.
How to connect smart downlight to Amazon Alexa
- Please tap”Me ->Third-Party Voice Services ->Alexa->Sign In With Amazon ” of Fitop APP to connect smart downlight to Alexa.
- If you don’t know the connection steps, you can learn the detailed instruction on page of the “Me ->Third-Party Voice Services ->Alexa ->View more ways to link”.
How to connect smart downlight to Google Assistant
- Please tap” Me ->Third-Party Voice Services ->Google Assistant ->Link with Google Assistant ” of Fitop APP to connect smart downlight to Google Assistant.
- If you don’t know the connection steps, you can learn the detailed instruction on page of the “Me ->Third-Party Voice Services ->Google Assistant ->View more waysto link”.
Fitop App
support for a Fitop product.
Contact us: Fitop_service@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>