APPLYLABWORK PT-SP001BK 2 and 3 Series Printers Laser Spring Black Instructions

: June 4, 2024
: APPLYLABWORK

Table of Contents

67- 64-1) for no more than 1 minute will significantly reduce tackiness.

APPLYLABWORK PT-SP001BK 2 and 3 Series Printers Laser Spring Black Instructions

Form 2 & 3 series printers Laser Spring Black (PT-SP001BK)

Check:

Resin tank and optical path are clean
Shake resin bottle well before use

Open-Mode (Form2):

Ensure the printer is idle

Tap printer icon on home screen
Select “Settings” menu
Select “Open Mode” function
swipe the bar on top right side to “On”

LT tank is required in Form2 printers

Cartridege (Form2 & Form 3 series):

Refill the resin to durable-v2 cartridge. Open air vent, turn cartridge upside down, drip dry through air vent for at least 5 mins to minimize cross contamination, refill, shake well for 2 minutes, insert and print. Alternative solution: North America , Other Regions

PreForm Setting:

Select Printer: Form2 or Form3 series
Select Material: durable v2
Layer Thickness: 100µm
please avoid any large aspect-ratio geometry (e.g. thin wall or long rod) in the object to reducre failures.

Washing:

Wipe off excess resin on prints with paper towel, submerge into 95% IPA and place the container in ultrasonic bath, wash for 5 minutes. Replace by clean IPA and repeat ultrasonic washing for another 5 mintes

(total 10 minutes). Blow off all excess IPA and set parts in a shaded airy place to dry at least 2 hours before curing.

*Dried print will be tacky to touch

Post-curing (Mandatory):

Submerge the parts into glycerol/glycerin (CAS # 56-81-5) and start FormCure with 60 ℃ / 30 mins setting. Wash off glycerol in water and dry off with paper towel.

*If prints don’t sink completely into glycerol, add water (no more than half of volume) to adjust liquid density.

**If prints are still tacky to touch afterpost-curing, rinse with acetone (CAS

67- 64-1) for no more than 1 minute will significantly reduce tackiness.

Storage:

Do NOT keep the resin in the tank more than one week. Pour out the resin and gently wipe the tank with paper towel and IPA.
Keep resin away from heat and light.
NOT accessible to children.

Note:

Keep printing environment well ventilated.
Wear gloves when handling Spring resin and avoid direct contact.
Vibration of the parts during printing might cause resin splash onto printer ’s cover. Use paper towel and IPA to clean immediately.
Form2 printers usually give better printing quality than Form 3 series using Spring resin.
Spring resin is sensitive to resin tank quality. Please use a new tank to print if repetitive failure occur, even within Form 3 tank lifetime
Spring resin should NOT use with food, drink, or on/in the human body unless specifically indicated