CREATIVE SBS E2400 Speaker User Guide
- June 17, 2024
- Creative
Table of Contents
SBS E2400 Speaker
User Guide
Safety instructions
- Please read the following before using Creative products:
- Use a mains plug that is appropriate for your country or region
- To be completely disconnected from the power input, the mains plug has to be disconnected/ detached from the mains
- Disconnect the mains plug when the device is expected to be unused for several days
Technical Specifications
Creative E2400
Power output
Satellite speaker: 6 Watts (RMS) per channel
Subwoofer: 13 Watts (RMS)
Total : 25 Watts
Signal-to-Noise Ratio: 2 70dB
Frequency Response: 45Hz – 20kH2
Input Rating: 220-230V~50 / 60H2 100mA
Supported file formats on USB Thumb drive input mode : MP3 (32 GB MAX)
FM radio scanning frequency: 82.5MHz – 108MHz
Equalizer settings are only available on USB Thumb drive playback mode only
tmportant Notice
The serial number for your Creative E2400 is located on the subwoofer. Please
write this number down and keep it in a secure place.
© 2015 Creative Labs Pte. Ltd. All rights reserved. Creative and the Creative logo are trademarks or registered trademarks of Creative Technology Ltd in the United States and/or other countries. All other trademarks are the property of their respective owners. Specifications are subject to change without notice. Actual contents may differ slightly from those pictured. Use of this product is subjected to a limited warranty.
Product Overview
- Source
- Scan
- Power I Source LED indicator
- Volume+
- Volume-
- Subwoofer PortTube
- Subwoofer Driver
- USB Drive Slot
- FM Antenna
- 3.5mm Aux-in
- Left Satellite
- Right Satellite
- Power Cord
To Power ON/OFF Speaker
- Speaker s at “Standby” mode when power supply is switched on, with the red LED flashing.
Please press the” Source” button to Power ON. Press and hold” Source” to et the speaker enter nto “Standby” mode again.
To Switch between Sources
- You can toggle through the input modes by pressing the” Source” button. Red LED is Aux, Green LED s USB, and Orange LED is FM.
| Button | Action | Inputs |
|---|---|---|
| Aux Input | USB Input | FM Tuner |
| Press | Track Selection | |
| Previous I Next | Channel Selection |
Previous I Next
Press and hold| Vol+ / Vol –| Vol+ / Vol –| Vol+ / Vol-
Scan| Press| Mute| Play / Pause| Mute
Press and hold| | | Auto Search
FM radio
Infra Remote
Control
- Power On or standby
- Mute: Turns volume off. Press again to unmute.
- 0 – 9: Press your desired track or stored FM station preset channel and press” to jump to respective track I FM station
- Aux: AUX input mode selection
- USB: USB input mode selection
- FM: FM tuner mode selection
- EQ: Normal, Classic, Pop, Jazz, Rock, Country (only in USB mode)
- Volume+: Volume level Up
- NextTrack
- Play I Pause
- Volume-: Volume level Down
- PreviousTrack
- When in USB mode. “NEXT”means next song; “PREV”means previous song; “PLAY/PAUSE” means play/pause. To choose song, press the number “0-9″and press” ” button on the remote control.
- When you enter FM mode, press and hold “ ” to automatic search FM radio stations. Press “Next” or “Previous” to change stored FM memory stations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>