PROJECT SOURCE RPV31-PS Large Pool & Spa Rechargeable Underwater Vacuum User Manual
- June 16, 2024
- PROJECT SOURCE
Table of Contents
PROJECT SOURCE RPV31-PS Large Pool & Spa Rechargeable Underwater Vacuum
QUICK SETUP
Assembly
Suction head assembly
Insert the suction head directly into the suction mouth of the pool vacuum
until the side tabs of the transparent case clip in the holes of the suction
head’s pivot.
Note: For vinyl liner and fiberglass pools it is recommended to keep the brush
on the flat nozzle
to avoid damaging the pool Telescopic pole (not included)
To release the telescopic pole, press down on both the side tabs
simultaneously, and then pull out the pole.
- Press down on both side tabs.
- Slide telescopic pole over pole connector/handle
- Allow tabs to snap into side holes on pole.
Telescopic pole connector assembly
- Press down the side pins of the connector/handle.
- Insert the pole connector inside the main body.
- Turn the connector in either direction until the pin is secured in the hole
- Pin will protrude through hole
Telescopic pole (not included)
- Press down on both side tabs.
- Slide telescopic pole over pole connector/handle
- Allow tabs to snap into side holes on pole.
To release the telescopic pole, press down on both the side tabs simultaneously, and then pull out the pole.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>