PROJECT SOURCE L-2 Refrigerator Water Filter User Manual

June 8, 2024
PROJECT SOURCE

PROJECT SOURCE L-2 Refrigerator Water Filter

INTRODUCTION

Thank you for purchasing this Project Source Refrigerator Water Filter. We’ve created these easy-t0-follow instructions to ensure you have a simple installation process. But, if you need more information than what is provided here, please visit Lowes.com, search for the item number and refer to the Guides& Documents tab on the product’s page.

TROUBLESHOOTING

PROBLEM

  • Missing O-Ring
  • Leaking
  • Slow Flow/No Flow

POSSIBLE CAUSE

  • Manufacturer Error
  • Improper Installation
  • Improper Installation/Trapped Air Inside of the Filter

CORRECTIVE ACTION

  • Call Customer Service for replacement: 866-389-8827
  • Remove and reinstall, ensuring the filter is securely installed within the refrigerator housing.
  • Submerge filter without safety cap in a bowl or sink full of water for 45 minutes to 1 hour, and reinstall.

CARE AND MAINTENANCE

This replacement filter cartridge is warranted to be free from defects in material and manufacture for one (1) year from the date of purchase. This warranty does not cover any failures resulting from abuse, misuse, alteration, or damage not caused by the manufacturer or failure to follow proper installation and use instructions. If the product fails to satisfy this limited warranty during the described period, the manufacturer will replace or refund the purchase price of the product.

SAFETY INFORMATION

WARNING

To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions. Installation shall comply with applicable state and local regulations. For cold water applications only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. This filter unit must be replaced every 6 months, at the rated capacity, or sooner if reduced water flow occurs. Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product. Protect from freezing.

INSTALLATION OVERVIEW

  1. Locate your existing filter and remove it by turning the filter counterclockwise. The filter will eject slightly with a clicking sound.
  2. Carefully remove the sanitary cap from the top of the new filter.PROJECT-SOURCE-L-2-Refrigerator-Water-Filter-FIG3
  3. Insert the new filter into the refrigerator filter housing. Hold the handle on the filter in a vertical position to insert the filter into the filter housing. Insert the filter and turn the filter a full 14 turn clockwise until you feel it stop. Note: Please ensure the filter is fully installed as it is required to activate the internal water valve. If the filter isn’t properly installed, you may experience a slow flow or a chattering noise. If this occurs, please uninstall and reinstall the filter ensuring the filter is fully installed.
  4. Run approximately 2.5 gallons of water from the dispenser periodically to clear the system and to receive a good flow. If the water flow is slower than usual, please repeat Step 3. Note: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hOurs.
  5. Inspect the filter for any noticeable leaks. If leaks are detected, please repeat Step 3.
  6. To reset the filter monitor light, please refer to your refrigerator owner’s manual for specific instructions.
  7. Locate the included Water Filter Replacement Calendar and follow the instructions on the label.

SPECIFICATIONS

  • Flow Rate: 5 gpm (1.89 Ipm)
  • Operating Temperature: 33-100 F (0.6°-38°C)
  • Min Operating Pressure: 30 psi (207 kPa)
  • Max Operating Pressure: 100 psi (689 kPa)
  • Capacity: 6 months or 300 gallons(1,136 liters)

This L-2/L-2-2 is Tested and Certified by NSF International against NSF/ANSI . Standard 42 and 53 for the reduction of chlorine taste and odor, Tetrachlorethylene Endrin, Carbon Tetrachloride, Trichlorobenzene, p-Dichlorobenzene. Refer to the performance data sheet for a complete list of claims. This L-2/L-2-2 is Certified by IAPMO R&T against NSF/ANSI Standard 42, 53, 372, 401 PA73 and CSA B483.1 for the reduction of Chlorine taste and odor, Lead, Cyst, VOCs Mercury, Asbestos, Pharmaceuticals (such as Naproxen, ibuprofen and Phenytoin), BPA, PFOAPFOS. Refer to Performance Data Sheet for a Complete list of claims.

The compounds under NSF/ANSI 401 have been deemed as incidental contaminants/ emerging compounds’

PROJECT SOURCE and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved.

If the item is no longer for sale, or if you have any questions or problems, please call our customer service department at 1-866-389-8827, 8 a.m. – 8 p.m., EST, Monday- Sunday. You could also contact us at partsplus@lowes.com or visit www.lowespartsplus.com.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

PROJECT SOURCE User Manuals

Related Manuals