luminii PS-DALI-DT8-D-96-24-AWNR Dali LED Driver Installation Guide
- June 16, 2024
- luminii
Table of Contents
DALI LED Driver 96 watt – Installation Instructions
Models PS-DALI-DT8-D-96-24-AWNR
PS-DALI-DT8-D-96-24-AWNR Dali LED Driver
Please read all instructions prior to installation and keep for future
reference!
This LED Driver is to be installed in accordance with Article 450 of the
National Electrical Code. The LED Driver must be installed in a well
ventilated area and free from explosive gases and vapors. Proper operation
requires the free flow of air AS this LED Driver is hardwired, it should only
be installed by a qualified electrician. Suitable For Dry Location.
| Input | 120 – 277 V AC, 1.1 A, 50/60 Hz |
|---|---|
| Output | 24 V DC, 4.0 A |
| Max. Wattage | 96 W |
Before installing, check the label and ensure the LED Driver has the proper input voltage, output voltage, and wattage for the job. Check the wire markings to ensure they match the wiring diagram below. Refer to table above for the maximum loads!
1.1 LED Driver can be mounted vertically or horizontally. With a minimum of 3”
clearance around LED Driver to provide proper air circulation.
PS-DALI-DT8-D-96-24-
1.2 Ensure that the Lutron Athena Wireless node has at least 1” clearance from
any metal such as conduit.
2.1 Remove the cover from top of the driver housing to expose the driver wires. Screws for cover will be found inside the housing.
3.1 Insert the 120-277V AC power into the driver housing from the electrical panel. Followed by bringing 24V DC low voltage conduit one for the LED & other for controller wires.
Please read all instructions prior to installation and keep for future
reference!
This LED Driver is to be installed in accordance with Article 450 of the
National Electrical Code. The LED Driver must be installed in a well
ventilated area and free from explosive gases and vapors. Proper operation
requires the free flow of air AS this LED Driver is hardwired, it should only
be installed by a qualified electrician. Suitable For Dry Location.
4.1 Insert the wire nut connections in the driver housing. Close housing cover
and secure using the eight screws.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>