SALTO RS485 Wireless BLUEnet Node and RFnet Node Installation Guide
- June 16, 2024
- SALTO
Table of Contents
SALTO RS485 Wireless BLUEnet Node and RFnet Node
Installation guide
The BLUEnet Node and RFnet Node are part of SALTO wireless system. They work
as a bridge, with the SALTO Gateway, between SALTO’s access control software
and wireless locks.
Electrical characteristic
Operation conditions
| Min | Typ | Max | Unit |
|---|---|---|---|
| Temperature | -20 | 25 | 70 |
| Humidity | 35 | 85 |
Cable requirements
RS485 Connection (AB) Generic twisted pair wire Note 1
Power Connection (Vdd): 24 AWG
Power Supply for SALTO RFnet
| Min| Typ| Max| Unit
---|---|---|---|---
Input Voltage| 7| 12| 28| V
Current consumption| | | 45 Note 2| mA
Power Supply for BLUENET
| Min| Typ| Max| Unit
---|---|---|---|---
Input voltage| -20| 25| 70| V
Current consumption RF Node| | | 45 Note 2| m A
Current consumption RFNet| | | 75 Note 2| m A
SALTO RFnet Characteristics
| Frequency Range | 2400-2483.5 Mhz |
|---|---|
| Standard | IEEE 802.15.4 |
| Indoor Radio Range | 10/15m |
| Max output power | 5dBm |
SALTO BLUEnet Characteristics
| Frequency Range | 2400-2483.5Mhz |
|---|---|
| RF Standard | Bluetooth Low Energy |
| Indoor Radio Range | 5m/10m |
| Max output power | 8dBm |
Mechanical installation
1 GANG ELECTRICAL STANDARD BOX
Electrical installation
RS485 bus termination resistor is needed (ON position) when the node is
located at the end of the bus.
Installation example
Signalling
The green (RFnet Node) or blue (BLUEnet Node) LED of the device indicates that the device is properly powered.
Operational test
Once the product is installed, follow these steps to check the correct
operation:
When SALTO Gateway and locks are installed, check that the RFnet Node or
blueNET Node is active in SALTO’s software.
Maintenance
The unit should be tested at least once a year as described in “Operational test”. Keep the device in a safe place!
Radio information
The environment has a direct impact on the range radiation (metal, concrete
walls…) The receiver device must be located facing the product antenna. Please
check your product’s device antenna position.
Recommended connectivity distance: 5m – 10m
European view
All contents current at time of publication.
SALTO Systems S.L. reserves the right to change availability of any
item in this catalog, its design, construction, and/or materials.
2023 SALTO Systems S.L.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>