superbrightleds FLT-X Flexible LED Tube Light User Manual
- June 4, 2024
- superbrightleds
Table of Contents
superbrightleds FLT-X Flexible LED Tube Light User Manual
Important: Read all instructions prior to installation.
Safety and Notes
- Warning: Switch off the supply power before any installation or wiring.
- Avoid looking directly at the light when illuminated.
- Do not install in a location that is in close proximity to a radiant heat source.
Wiring (non-vehicle)
Wiring (vehicle)
Cutting to Length
-
Carefully remove attached end cap and strip from the wired end of the tube/housing.
-
Cut strip to desired length using cut marks located on back of strip.
Note: Cuts must be made in order to remove the section opposite of the wired end. -
Use the section of strip that was removed to measure and trim length of the tube/housing.
-
Slide strip back into tube/housing, making sure end caps are firmly in place.
Note: Silicone sealant can be used on the end caps for additional water resistance as needed.
Bending and Mounting
4400 Earth City Expy, St. Louis, MO 63045
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>