Jlrgear STG6955KB Over Ear Headphone User Manual
- June 15, 2024
- jlrgear
Table of Contents
Jlrgear STG6955KB Over Ear Headphone
Bluetooth headphone user manual
Easy Pairing (First Time Pairing)
-
Turn your headset on.
Once the headset is on, it will automatically enter pairing mode.
A white and a red LED indicators will start flashing. -
On the device you wish to pair, find the list of Bluetooth devices and “Search for” or “Add” new devices.
Select ” Pro Headphones ” from the list of devices.
Controls
- Power on/off, Accept/end phone calls, play/pause music
- +/ Volume up/Next track
- -/ Volume down/Previous track
Answering a Call
- When there’s an incoming call, the headset will ring.
- Briefly press the “PLAY/PAUSE” button to answer the incoming call.
- You can also double press the “PLAY/PAUSE” button to decline the incoming call.
Ending Call
While in a call briefly press the “PLAY/PAUSE” button.
Last number Redial
Double press the “PLAY/PAUSE” button to redial your last number.
Audio Streaming
- Play: Briefly press the “PLAY/PAUSE” button.
- Pause: While playing music, briefly press the “PLAY/PAUSE” button.
- Next song: Press and hold the “+” button.
- Previous song: Press and hold the “-” button.
- Volume up: Briefly press the “+” button.
- Volume down: Briefly press the “-” button.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not gause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off™ and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>