Jlrgear HT-Z2 15 Watt Wireless Charging Pad User Manual
- June 10, 2024
- jlrgear
Table of Contents
HT-Z2 15 Watt Wireless Charging Pad
User Manual 15-Watt Wireless Charging Pad
Product Introduction
Thanks for purchasing our product penholder wireless charging lamp. It adopts high-end quick charge IC ,with its luxury and compact design, it can be compatible with any mobile phones with QI standard. it can perfectly compatible with Sam sung, Apple fast charge wireless function, to save more time effectively and improve your charging experience.
Standard Accessories
1 Wireless Charger
1 USB Cable
1* User Manual
Applicable Devices
- Devices with built-in quick charge/normal charge wireless receiver.
- Devices with outerface wireless charging receiver.
- Devices with wireless charging receiver in its protection case .
Note: All devices must be Qi standard.
Instructions
-
Connect the wireless charger to the AC power supply through the power adapter, turn on the wireless charger, the indicator light turns blue within 3 seconds, and then the indicator turns off and enters the standby mode.
-
Place your device vertically or horizontally in the center of the Wireless Changer until your device begins to charge.
-
The LED indicator light will become steady blue when charging mobile phone.
Specifications
- Product name:Wireless charger
- Input voltage: 5V/3A 9V/2A
- Charging efficiency: 70%-80%
- Input power : 18W max.
- Output power: 15W/10W/7.5W/5W
- Dimension: 100x12mm
- Dimension: 100x12mm
Attention
- Please keep the charger away from water or other liquid.
- If you need to lean the charger, please make sure it is power off.
- Using Environment tempeature remain 1-45 degree.
Warranty Card
During the product warranty period , if the fault is caused by the quality of the product itself, the user is requested to contact the dealer with this warranty card and purchase certificate to enjoy free repairs. Free naubgannance us bit available in the following situations:
- There is no warranty card or the product repair label has been damaged.
- Damage caused by self-disassembly.
- Failure and man-made mechanical damage caused by water ingress or falling.
- Failure or danage casued by force majeure.
Product name:………………………………..
Client name(buyer’s name):………………..
Sale address:…………………………………
Sale date: Remark:……………………………
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Made In China
Documents / Resources
|
Jlrgear HT-Z2 15 Watt Wireless Charging
Pad
[pdf] User Manual
2AMG5-STG6883, 2AMG5STG6883, HT-Z2 15 Watt Wireless Charging Pad, 15 Watt
Wireless Charging Pad, Wireless Charging Pad, Charging Pad
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>