luminii PDC-96-24 PDC Pure DC Power Supply Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii PDC-96-24 PDC Pure DC Power Supply
Please read all instructions prior to installation and keep for future
reference!
This power supply is to be installed in accordance with Article 450 of the
National Electrical Code. The power supply must be installed in a well-
ventilated area and free from explosive gases and vapors. Proper operation
requires the free flow of air. As this power supply is hardwired, it should be
installed by a qualified electrician. UL class 2 recognized.
FEATURES
Installation Instructions
-
Before installing, check the label and ensure the power supply has the proper input voltage, output voltage, and wattage for the job. Check the wire markings to ensure they match the wiring diagram below. Refer to table above for the maximum loads!
- The power supply can be mounted vertically or horizontally. With a minimum of 3” clearance around power supply to provide proper air circulation.
-
Remove the three Phillips screws from the top of the driver housing and pull the cover off to expose the driver wires.
-
Insert the 120-277 VAC power into the driver housing from the electrical panel. Followed by bringing the 24V DC low voltage wires from the LEDs into the driver housing. In addition, connect the Triac / Phase dimmer at input if applicable. Refer to the diagram on page 2 to make all the proper wiring connections.
-
WIRING DIAGRAM
NOTE: This unit needs to perform load calibration when use for the first time or load is changed. Please run the unit with dimmer at max level for 10 seconds. During load calibration, the output of the unit will delay for 2 – 3 seconds.
-
Insert the wire nut connections in the driver housing and close the housing cover. Secure by tightening the three screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>