wolfcraft X43 Pro Multi Diamond Disc Instruction Manual
- June 15, 2024
- wolfcraft
Table of Contents
**wolfcraft X43 Pro Multi Diamond Disc Instruction Manual
**
Safety and usage instructions:
When using diamond cutting discs, always observe the following points:
- Install the cutting disc so that it does not wobble sideways or up and down
- Adhere to the optimum speed according to the manufacturer‘s instructions
- Do not clamp or jam the cutting disc
- Clamp the material to be cut firmly
- Move the machine back and forth in the material (pendulum cutting)
- Do not apply excessive grinding pressure; the weight of the machine is sufficient
- Work only with a safety shield
- Wear safety goggles and protective clothing
- Make sure you have a secure footing
- For wet cutting, use a protective transformer
- Discs to be used for dry cutting:
Cutting depth| Disc diameter
---|---
2 cm| to Ø 125 mm
approx. 3 cm| Ø 178 mm
approx. 4 cm| Ø 230 mm
approx. 4.5 cm| Ø 300 mm
Special note for dry cutting:
Take breaks to allow for cooling
After approximately 2 minutes of cutting, the machine must be stopped for a
cooling period. Allow the machine to idle for up to 1 minute.
If the cutting ability of the disc diminishes, it can be sharpened by cutting
into sand lime bricks.
Guarantee :
No guarantee can be given in the event of improper use.
Complaints regarding the supplied diamond cutting discs will only be accepted
up to 1 mm of segment height wear.
wolfcraft GmbH Wolffstraße 1 56746 Kempenich Germany
info@wolfcraft.com
www.wolfcraft.com
Documents / Resources
|
wolfcraft X43 Pro Multi Diamond
Disc
[pdf] Instruction Manual
X43 Pro Multi Diamond Disc, X43 Pro, Multi Diamond Disc, Diamond Disc
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>