ET2 E24926 Palla LED Single Pendant Ceiling Light Instruction Manual

June 15, 2024
ET2

ET2 E24926 Palla LED Single Pendant Ceiling Light Instruction Manual
ET2 E24926 Palla LED Single Pendant Ceiling Light

Please consult a qualified electrician prior to install

Before Getting Started

Read the instructions carefully prior to assembling the product.

When you open the package with a sharp tool like a box knife, be careful not to damage the components inside.

Carefully remove all packaging materials and retain for future use.

Keep all hardware parts and packaging out of reach or small children.

Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.

Ensure that you have all required contents for complete assembly.

Take care when lifting. Assemble the product in close proximity to where you intend to install it.

Do not over tighten the screws and bolts as this may damage the threads.

Do not let children play with this product.

! Risk of suffocation!
Keep packaging materials away from children.

Lamp Care Instructions

Carefully read through the instruction sheet before assembly and using the product.

Caution there is a risk of shock!
Disconnect from power source before assembling or cleaning.

Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.

Only use the recommended bulb type and do not exceed the maximum wattage as it could cause fire.

Check the product cord to be sure is free torn or frayed.

PARTS

Before getting, started, ensure the package contains the following components:

A X1
B X1
C

#8-32 x 1.25″

| X2
D| | X2
E| | X3
F| | X2

Installation Instruction

Installation Instruction
Installation Instruction
Installation Instruction

IMPROPER WIRING and/or INCORRECT DIMMER use can cause CATASTROPHIC DAMAGE!

THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH

DO NOT CUT FACTORY-MADE CONNECTIONS.

AC 120V~60Hz
Installation Instruction

VERIFIED LIST OF TESTED DRIVERS

Lutron Diva DVCL-153P
Lutron Diva DVELV-300P
Lutron Caseta
DEAKO-Smart Dimmer
DEAKO-Single Dimmer
Leviton Sureslide 6613-P
Leviton Illumatech IPI06-1LZ
Leviton Decora 6674

GENERAL COMPATIBILITY

TRIAC / FORWARD PHASE ELV / REVERSE PHASE ONLY at 120VAC
Due to inrush current, wattage should not exceeed 150W on a 600W dimmer

IMPORTANT!

If the control is not paired properly to LED fixtures, irreparable damage may occur.

If the dimmer you are using is not listed here, consult a lighting professional or view our Dimming Compatibility Chart online:
www.et2online.com

ET2 Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ET2 User Manuals

Related Manuals