Schreder VALENTINO GEN2 Classical Street Lamp Installation Guide
- June 15, 2024
- Schreder
Table of Contents
Schreder VALENTINO GEN2 Classical Street Lamp
Product Information
Specifications
- Type: Valentino Gen2
- Voltage: 230V
- Length: 4m – 10m
- IP Rating : TBD
- IK Rating : TBD
- DP Rating : TBD
- FG Rating : TBD
- Compliance : EN60598
- Frequency : 50Hz
- Mass: 9.9kg (Post-Top D60), 8.7kg (Post-Top 3/4”), 8.8kg (Suspended 3/4”)
Product Usage Instructions
Packaging
The product comes with the following items
- 1x Post-Top D60
- 2x Post-Top 3/4”
- 1x Suspended 3/4”
Mechanical Installation
Flat Glass – Post-Top
- Attach the product without the main cable using the extra clip.
- Secure the product using two M5 screws with a torque of 2 Nm.
- Attach the product to the pole using six M8 screws with a torque of 12 Nm.
- Ensure a minimum distance of 70mm between the product and the pole.
Deep Protector – Post-Top
- Attach the product with the main cable without the extra clip.
- Secure the product using two M5 screws with a torque of 2 Nm.
- Attach the product to the pole using six M8 screws with a torque of 12 Nm.
- Ensure a minimum distance of 70mm between the product and the pole.
Suspended
- Attach the product without the main cable.
- Secure the product using two M5 screws with a torque of 2 Nm.
- Ensure a minimum distance of 30mm between the product and the ceiling.
Electrical Installation
Follow the electrical installation instructions provided in the user
manual.
Tilting Angle
The tilting angle of the product is 640mm.
Connection
Make sure to properly connect the line and neutral wires according to the
provided instructions.
FAQ
-
What is the voltage requirement for the Valentino Gen2?
The Valentino Gen2 requires a voltage of 230V. -
What is the IP rating of the product?
The IP rating of the product is not specified in the user manual. -
What is the IK rating of the product?
The IK rating of the product is not specified in the user manual. -
What is the DP rating of the product?
The DP rating of the product is not specified in the user manual.
VALENTINO GEN2
Installation instructions
Packaging
Mechanical installation
FLAT GLASS – POST-TOP
DEEP PROTECTOR – POST-TOP
SUSPENDED
G 3/4’’ MALE
Electrical installation
Tilting angle
Connection
SAFETY INSTRUCTIONS
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. Always switch off the power prior to installa-tion, maintenance or repair activities.
RISK GROUP 2 – CAUTION! Hazardous optical radiation may be emitted from
this product. Do not stare at the luminaire when operating as it may be
harmful to the eyes. The luminaire should be positioned so that prolonged sta-
ring at the luminaire at a distance of less than 0.77m is not expected.
This product contains a light source of an energy efficiency class G or
higher.
In case of PVC insulated mains cable, the ins-taller MUST ensure that the
WHOLE cable is protected against climatic conditions, especially UV rays and
rain, by making sure that the cable is contained inside the luminaire and pole
Y-connectio n: In case of damage to the wire, it has to be replaced only by the manufacturer, distributor or by an expert, to avoid risks.
