8BitDo M30 2.4G Wireless Controller Instruction Manual

June 15, 2024
8Bitdo

M30 2.4G mini
Instruction Manual

M30 2.4G Wireless Controller

8BitDo M30 2.4G Wireless Controller - Select Mode

  • Press the Start button to turn on the controller
  • Hold the Start button for 3 seconds to turn off the controller
  • Hold the Start button for 8 seconds to force the controller off

MD mini / MD mini 2 / Genesis mini

Wireless Connection

  1. Connect the 2.4G receiver to the USB port of your MD mini / MD mini 2 / Genesis mini console
  2. Press the Start button and wait until the controller is recognized by the system to play

Switch

  • Switch system version needs to be 3.0.0 or above
  • Please ensure the [Pro Controller Wired Communication] is enabled in the system setting

Wireless Connection

  1. Connect the 2.4G receiver to the USB port of your Switch
  2. Press the Start button and wait until the controller is recognized by the system to play

Wired Connection

  • Connect the controller to the Switch via a USB cable and wait until the controller is recognized by the system to play

Windows

  • Windows 10 (1903) or above is required for your Windows device

Wired Connection

  1. Connect the controller to the USB port of your Windows device and wait until the controller is recognized by the system to play

Turbo Function

  • The D-pad, Start, Mode and Home buttons are not supported
  • Hold the button you would like to set turbo functionality to, then press the Star button to activate/deactivate its turbo functionality

Battery

Status – LED indicator –
low battery Red LED blinks
battery charging Red LED stays solid
battery full charged Red LED turns off
  • 35 hours of play time with a 480 mAh built-in lithium battery pack, fully recharge between 1 to 2 hours
  • The controller will automatically shut down if there is no connection within 1 minute after startup or no activity within 15 minutes after connection
  • The controller will not shut down when it’s over wired connection

Repair the controller with the receiver
If the controller loses the connection with the receiver or need to pair with another same model 2.4G receiver, please follow the instructions below:

  • Press the Start button to turn on the controller, hold the mode button for 3 seconds to enter the pairing mode, the status indicator starts to blink rapidly
  • Connect the 2.4G receiver to your device
  • Both status indicators become solid when the connection is successful

Support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals