Sanctuary SA-PLAT Home Office Biometric Safe Installation Guide

Sanctuary SA-PLAT Home Office Biometric Safe

QUICK START GUIDE

INITIAL ENTRY

• A. Install the single spoke by right clockwise inserting opening until into and you the feel twisting upper the spoke fully lock into place.

• B. Insert the backup key and o’clock clockwise turn the position from 12 backup to to unlock.the key 3

• C. Turn the handle clockwise and pull the safe door open. not Once which close will opened, during extend turn setup. the the locking handle Remove bolts back the to and backup its ensure starting key the and safe position set aside.
  SA-PLATI handle will rotate counter-clockwise

• D. Remove the lock face from the box located inside of the safe.

INSTALL BATTERY

• A. Locate the lx9V the battery battery. Install the compartment it into on face the in the back of proper the lock are will orientation. beep successfully when The keypad is installed.batteries

LOCK FACE INSTALLATION

• A. Plug the electronic lock lock cable face. into The the back connector of into the on the the face in cable one connector will way. in only the fit lock
• B. Align the lock face to lock the face backer slightly plate, with rotated the to the left. you into feel Turn place the clockwise lock face until click

HANDLE INSTALLATION

• A. Once the lock face has been installed, locate the remaining spokes inside of the safe. Insert each individual spoke into a threaded opening and turn clockwise to install.
  Note: The SA-PLATI model only requires a single spoke. No additional spokes will need to be installed.

PROGRAMMING

• A. To begin, open door and extend locking bolts during programming.
• B. Remove the brass cap on the inside of the safe door.
• C. Press the reset button. You will hear 2 beeps and the keypad will illuminate. You are now in programming mode.
• NOTE: Programming mode will time out after 10 seconds. Press restart button and begin again.
• D. Input your new 3-8 digit code followed by the [* ] symbol.
• E. (2) beeps and (2) green unlock LED flashes mean the entry was successful. (3) beeps and (3) yellow lock LED flashes mean your code was not accepted. Press the reset button and start again.

TEST YOUR NEW CODE: While the safe door is still open.

• Swipe finger(s) across the keypad to activate the lock face. Two random numbers will illuminate. Press them in any order
• Enter your newly programmed code followed by the (#) symbol.

If successful you will hear (2) beeps and (2) green unlock LED flashes. You will now be able to retract the bolts. If unsuccessful, repeat programming.

ACCESS

• A. WitE. Be chain the spoke hub is rotated completely counterclockwise.
• B. Swipe finger(s) across the keypad to activate the lock face. Two random numbers will illuminate. Press them in any order.
• C. Enter your security code followed by the (#) button. The yellow lock LED will flash 2 times followed by the green unlock LED if your code is accepted. If it is rejected, yellow lock LED will flash 3 times and beep 3 times.

PLEASE REFER TO THE MANUAL FOR TROUBLESHOOTING AND SHELF INSTALLATION

INSTRUCTIONS

This quick start guide is meant to simplify the process of getting
started. The manual also provides in-depth instructions.

WE ARE HERE TO HELP!

If you still have questions or concerns about your vault please contact our customer service team.

• cs@saproducts.com or
• 888.792.4264
• BEFORE RETURNING

Documents / Resources

| Sanctuary SA-PLAT Home Office Biometric Safe [pdf] Installation Guide
SA-PLAT Home Office Biometric Safe, SA-PLAT, Home Office Biometric Safe, Office Biometric Safe, Biometric Safe, Safe
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>