ET2 E30565-20PC Charm Linear Pendant Ceiling Light Instruction Manual
- June 15, 2024
- ET2
Table of Contents
**ET2 E30565-20PC Charm Linear Pendant Ceiling Light Instruction Manual
**
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be careful not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
- Risk of suffocation!
Keep any packaging materials away from children.
Low Voltage LED Lighting Instructions
Carefully read through the instruction sheet before assembly and using the product.
Caution there is a risk of shock. Disconnect from power source before assembling or cleaning.
WARNING: Wires need to be connected to driver found in canopy and should not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer.
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass cleaner, acrylic polish, and wood polish.
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching, or even cause color to fade.
Package Contents
Before getting,started, ensure the package contains the following components:
| A | X1 | |
|---|---|---|
| B | X1 | |
| C | ||
| SCREWS L1″ | X8 | |
| D | ||
| SCREWS L0.47″ | X6 | |
| E | ||
| SCREWS 8#-32N 1″ | X2 | |
| F | X3 | |
| G | ||
| LED DRIVER | 120V 30-42V 700mA | TRIAC/ELV L3.78″ x W1.53″ x H0.98″ |
| H | ||
| LED DRIVER | 120V | 22-32V |
Assembly Instruction
WIRING DIAGRAM (ONLY FOR REFERENCE)
DO NOT ATTEMPT TO CUT FACTORY CONNECTIONS WITHOUT QUALi ED KNOWLEDGE.MODIFICATIONS MADE TO THIS PRODUCT WITHOUT THE CONSENT OF THE MANUFACTURER WILL VOID WARRANTY.
-
AC:120V/60HZ
-
AC:120V/60HZ
-
AC: 120V/60HZ
SCHEMATIC FOR GENERAL REFERENCE ONLY.
SEND PRODUCT INQUIRIES TO INFO@ET20NLINE.COM
Must be installed by a licensed electrician with knowledge of electronic lighting systems.
@ 2022 MAXIM LIGHTING GROUP
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>