W hler VE HD Video Endoscope Probe 180 Panable User Manual
- June 15, 2024
- W HLER
Table of Contents
**W hler VE HD Video Endoscope Probe 180 Panable User Manual
**
General
Intended Use
The HD video endoscope probe 180°panable can only be used together with the endoscopes Wöhler VE 220, VE 320 or VE 400.
Adress
Wöhler Technik GmbH
Wöhler-Platz 1
33181 Bad Wünnenberg
Tel.: +49 2953 73-100
E-Mail: info@woehler.de
Important Notes
Warning!
Do not use the probe and endoscope in an explosive environment.
ATTENTION!
The probe may only be connected to the Wöhler VE 220, 320 and 400 endoscopes.
ATTENTION!
Make sure never to twist or kink the probe cable.
ATTENTION!
Never turn the rotary knob on the probe handle more than a quarter turn in any
direction.
ATTENTION!
Stand the probe tip upright before pulling the probe out of the inspection
port. The Wöhler logo on the rotary knob is then exactly parallel to the probe
handle.
ATTENTION!
Dry the probe after contact with liquid and make sure that it is stored in a
dry place.
Technical Data
| Description | Details |
|---|---|
| Probe diameter | 6,2 mm |
| Probe length | 150 cm |
| Focal Distance | 20 – 100 mm |
| Field of view (FoV) | 100° |
| IP class | IP 67 (Temporary immersion up to a maximum of 30 minutes) |
| Lightning Source | 6 LEDs |
Design
Connecting the probe
- To connect the probe to the monitor, insert the probe into the female connector ensuring the notch on the male connector is precisely aligned with the red dot on the female connector.
- Then tighten the gland nut finger-tight.
NOTE!
Connect the camera probe before switching on the Wöhler VE. If you connect the
probe when the device is switched on, you will need to restart the Wöhler VE.
Operation
- Switch on the Wöhler VE and operate it as described in the Wöhler VE operating instructions.
- To swivel the probe tip 180° to the left or right, turn the rotary knob to the left or right.
The probe tip is 0° straight ahead when the Wöhler logo on the rotary knob is parallel to the handle.
ACHTUNG!
Never should the rotary knob be turned more than a quarter turn in any
direction.