W HLER VE 220 HD Endoscope Videos User Manual
- June 12, 2024
- W HLER
Table of Contents
- General Information
- Technical Data
- Component explanation
- Component explanation
- Video inspection with the app
- Inspection view
- Photo
- Video recording
- Picture and photo gallery
- Troubleshooting
- Warranty and Service
- Declaration of conformity
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Operating manual Video Endoscope
Wöhler VE 220
Best.-Nr. 25001– 2022-08-10
Technik nach Maß
General Information
1.1 Operation Manual Information
This operation manual allows you to work safely with the Wöhler VE 220
Video Endoscope. Please keep this manual for your information.
The Wöhler VE 220 Video Endoscope should be employed by professionals for its
intended use only.
Liability is void for any damages caused by not following this manual.
1.2 Notes
WARNING!
Not following this warning can cause injury or death.
ATTENTION!
Not following this note can cause permanent damage to the device.
NOTE!
Useful information
1.3 Intended Use
The Wöhler VE 220 Video Endoscope is used for the inspection of small
cavities from Ø 20 mm on (e.g. roof insulation, exhaust pipes, washbasins,
fireplaces).
The Wöhler VE 220 transfers the images and videos by WLAN to a tablet or
smartphone.
1.4 Scope of supply
Device | Scope of supply |
---|---|
VE 220 Video Endoscope | Video Endoscope |
Probe (1 m) with mini camera head Ø 7.6 mm
USB-C-cable
side view mirror, magnet (pluggable), hook attachment
Plastic case
Smartphone Support
1.5 Storage and transport
ATTENTION!
Improper transport can harm the instrument.
Always transport the Video Endoscope in the provided carrying case in order to
prevent damage.
ATTENTION!
When rolling up the probe, take care that the diameter is not smaller than the
diameter of the probe section in the case.
1.6 Information on disposal
Electronic equipment does not belong into domestic waste, but must be
disposed in accordance with the applicable statutory provisions. You may hand
in any defective batteries taken out of the unit to our company as well as to
recycling places of public disposal systems or to selling points of new
batteries or storage batteries.
1.7 Direction
Wöhler Technik GmbH
Wöhler-Platz 1
33181 Bad Wünnenberg
Tel.: +49 2953 73-100
Fax: +49 2953 73-250
E-Mail: info@woehler.de
Technical Data
Description | Data |
---|---|
WLAN | IEEE 802.11 b/g/n |
Network Standard | Built-in IPEX antenna |
Antenna | 2.4 GHz |
Data Rate
(802.11 a/b/g/n)| up to 150 Mb per second
Camera head| 7.6 mm Ø
Resolution| 1.0 Mega pixel CMOS
Depth of Field| 30 mm to 100 mm
Resolution| 1280 x 720 pixel 960 x 720 pixel
Viewing angle| 70°
Probe length Files| 1 m
photos: jpg
videos: AVI
Light source| 8 LEDs
Additional Light| 1 W LED flash light
Current supply| lithium-ion battery 2600mAh, 3.7 V
ncapsulation camera head| IP 67
Component explanation
3.1 Components
Explanation
- Camera probe
- Camera head
- Union nut
- Flash Light Button
- Flash Light
- USB-C port for charging the battery
- smartphone holder
- Support for smartphone or iPhone
- ON/OFF-key
- LED Adjust Wheel
3.2 Funktion
The Wöhler VE 220 video endoscope sets up its own WLAN network as soon as it
is switched on.
Via this network, it transmits videos to the Wöhler VE App. The App can be
downloaded for free to mobile devices with Android or iOS operating systems.
Images (JPG) and videos (AVI) can be savedon the end device.
Component explanation
- Do not expose the optics to sudden temperature changes.
Attention!
If the lens have heated while working, there is the danger of bursting when it comes into contact withcold water.
4.1 On/Off-key
- Press the ON/OFF key to switch the Video Endoscope on and off.
- To turn off, press and hold the ON/OFF button for 3 seconds.
- ON/OFF button flashes blue: no Wi-Fi connection to the app established.
- ON/OFF button lights up blue: WLAN connection to the app established.
- ON/OFF button flashes blue very quickly: low battery voltage (<10%), charge device.
4.2 Switching on the Flashlight
For an inspection in a dark environment the flash light should be switched on.
- Switch the flash light on and off by pressing the flash light key.
4.3 Assembling the Probe
-
The probe can be removed for transport and storage.
-
Loosen the union nut and remove the probe.
-
To assemble the probe again, proceed as follows:
ATTENTION!
The probe connection has a small notch. Take care to plug the notch on the small nose piece of the plug connector. For better orientation, a red dot below the notch also helps. -
After that tighten the union nut.
4.4 Charging the battery
If the battery voltage is low, the LED of the ON/OFF-key will flash blue very quickly.
- In this case, charge the device via a USB-C charging cable.
- Connect the USB-C cable to the power supply via the USB-C port on the bottom of the device.
- During the charging process, the LED of the ON/OFF key lights up red. The endoscope can continue to be used during this time.
Video inspection with the app
5.1 Loading the app onto an Android smartphone or tablet
- Download the free “Wöhler VE” app to your mobile device (smartphone or tablet) before using it for the first time.
The app is in English.
Verbinden des Wöhler VE 220 mit dem mobilen Endgerät
To be able to use the app, you must connect the Wöhler VE 220 to the mobile end device. To do this, proceed as follows:
-
Switch on the Wöhler VE 220.
The device will now set up its own WLAN network. -
Go to the WLAN settings of your mobile device.
There you will now see the Wöhler VE 220 as “WIFI Cam”. -
Select WIFI Cam.
The Wöhler VE 220 will now connect to your enddevice.
NOTE!
As long as the Wöhler VE is connected to the app on your mobile end device,
this end device is not connected to the internet.
Using the Wöhler VE
After opening the app, the Wöhler VE 220 and Wöhler VE 220 devices are displayed.
- Tap the green button (Connected) to start video viewing.
NOTE!
If no Wöhler VE Endsocope is connected to the end device, both buttons are
gray (offline), so that the display cannot be opened.
Inspection view
The inspection view shows the live images of your inspection.
- To exit the inspection view, tap the X in the header
8.1 Image resolution
- In the header of the Inspect view tap on the resolution.
Now you have the possibility to choose between two image resolutions: 1280 x 720 and 960 x 720 pixels.
Photo
- Tap “Photo” in the footer and then tap the blue dot to take a photo.
Video recording
- Tap “Video” in the footer and then tap the red dot to start a video recording.
During video recording, the current recording time is displayed. The recording time is not limited.
- Tap the white square to stop the video.
Picture and photo gallery
-
To view all image and video recordings, tap Gallery.
In the gallery you can see all the pictures and videos taken with the Wöhler VE 220 so far. -
Tap on an image or video to display it.
11.1 Delete
- To delete an image or video, select it and then tap the trash icon.
11.2 Sending from the appgallery
- To send one or more images or videos, select it and tap the share icon.
- The image cannot be sent until the WLAN connection of the end device has been disconnected from the Wöhler VE 220 and a general Internet connection has been established.
- To return from the gallery back to the inspection view, you must connect the mobile end device to the Wöhler VE 220 again via the WLAN settings.
11.3 Transferring all image and video files from theinternal memory
NOTE!
Images and videos are stored in the internal memory of the mobile device if
you allow access when you first open the Wöhler VE App. Only in this case the
following applies:
Android:
You can also find all files recorded via the app in the internal memory of
your mobile device under Pictures/Smart/Endoscope/VE 220 as well as in the
gallery of your mobile device.
iOS:
You can find all files taken via the app under “Photos”.
From there you can transfer, delete or send all files as soon as your end
device is connected to the Internet.
Troubleshooting
Problem | Solution |
---|---|
No image | Check that the probe is correctly connected to the endoscope. |
Automatic shutdown after 1 minute | Battery voltage low. Charge the device. |
Warranty and Service
13.1 Warranty
Each Wöhler VE 220 videoendoscope is tested in the factory in all functions
and leaves our factory only after a detailed quality control.
When used properly, the warranty period of the Wöhler VE 220 video endoscope
is 12 months from the date of sale.
The costs of transport and packing of the device in case of repair are not
covered by this warranty.
This warranty is void if any repairs or modifications have been made to the
unit by a third party not authorized bythe manufacturer.
13.2 Service
SERVICE is very important to us. Therefore, we are of course also there for
you after the warranty period.
- You send the device to us, we repair it within a few days and send it to you with our parcel service.
- Immediate assistance is available from our technicians on the phone.
Declaration of conformity
The product
Product name: Wöhler VE 220 Video Endoscope
complies with the key safety requirements set down in the guidelines of the
Council for the Harmonization of the Legal Requirements of the Member States
in relation to the electromagnetic compatibility.
The following standards were availed of to evaluate the product in respect of
the electromagnetic compatibility:
EN 62311:2008
ETSI EN 301 489-1 – V2.2.3 (2019-11)
ETSI EN 301 489 – V3.2.4 (2020-09)
ETSI EN 300 328 V2.2.2: 2019-07
Bad Wünnenberg, 10.08.2022
Johannes Lötfering, Geschäftsführer/Managing Director
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>