HOWARD LRX1 Series Lighting Solutions Installation Guide
- June 6, 2024
- HOWARD
Table of Contents
LRX1 Series
Installation Instructions
| Model | LxWxH | Input (V) | Wattage (W) |
|---|---|---|---|
| LRS1DMV*YY$$%***** | 18 X 9 X 4 | 120-277V AC | |
| 50 / 60Hz | 40 |
LRM1GMV*YY$$%*
LRM1LMVYY$$%
LRM1VMV*YY$$%*”| 22 X 11 X 4| 75
100
150
LRL1KMV*YY$$%***
LRL1SMV*YY$$%*****| 26 X 13 X 4| 200
240
Code represents:
-
represents LED Lens, it may be 2,3,4,5; 2 = Type II, 3 = Type III, 4 = Type IV, 5 = Type V
YY represents CCT, it maybe: 2K,3K,4K,5K, 6K; 2K = 2700K,3K=3000K,4K=4000K, 5K=5000K,6K=5700K
$$ represents Body color, it maybe: Gray(GY),Black(BK),Bronze(BR)
% represents SPD type,it may be 1or2; 1 = 10kV/10kA, 2 = 20kV/20kA
The second “*****” = blank or any alphanumeric characters for marketing purpose- Open the door by rotating the latch clockwise.
- Loosen the fitter bolts to accommodate the pole tenon.
- Insert the tenon into the opening, through the wildlife guard.
- Position the tenon on the desired tilt step, and tighten the fitter bolts by hand. Adjust the roll with the bubble level. Tightenthitter bolts to 10ft-lbs.
- Make the appropriate electrical connections, and torque the terminals to 40in-lbs.
- Confirm luminaire ratings match the supply circuit.
- Confirm the shorting cap or photoelectric control is rated for the supply circuit, and install by inserting and rotating clockwise.
- Check electrical and mechanical connections and close the door securely.
-This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
**** -THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED -MIN 90°C SUPPLY CONDUCTORS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>