KSR LIGHTING KSR7164 Tilo 6W 3000K LED Wall Light Installation Guide
- June 4, 2024
- KSR LIGHTING
Table of Contents
KSR LIGHTING KSR7164 Tilo 6W 3000K LED Wall Light
Read these instructions before commencing installation. Please give these instructions to the owner/occupier after installation to retain for future reference/maintenance.
These fittings are Class I and must be Earthed
Important Information
It is recommended that these luminaires are installed and fitted by a qualified electrician ensuring the installation complies with current IEE wiring regulations & local building control. These products are designed for connection to a 240V~50Hz supply. Any faulty, broken or damaged luminaires should be replaced immediately. KSR will not accept responsibility for any claims arising from a poor installation.
Please Note: The limited warranty shall be deemed null and void in the following circumstances: Failure by the installer, end user or any third party to exercise caution to protect any covered product or part from outside damage, adverse temperature (normal operating ambient temperature -15 – +35°C), humidity conditions, fluctuations in the electrical system or physical abuse as well as failure related to the workmanship in the installation of the products or parts.
Important User Advice
Always switch off mains supply before servicing. This luminaire is suitable for Outdoor use. KSR recommends a regular cleaning schedule is maintained to preserve the finish and light output of the product throughout its operating life. Do not use Megger or similar high-voltage instruments. Due to the fact this luminaire contains electronic components that maybe damaged by high test voltages, they must be disconnected from the circuit before testing. To prevent damage to the driver, do not mix with conventional magnetic ballasts on the same electrical circuit. At the end of life the luminaire is classed as WEEE under directive 2014/30/EU and should be disposed of in accordance with local legislation.
Installation Procedure
- Familiarize yourself with the luminaire/installation procedure and ensure the power is safely isolated before installing the luminaire.
- Locate Area(s) suitable for installation.
- Using the Allen key provided release the grub screw located on the top side of the luminaire
- With the screw loosened off gently pry the back plate away from the body
- Pull Cable through Grommet provided, being careful to make a small hole in grommet to ensure a good seal between supply cable and grommet
- Connect the mains 240V~50Hz supply into Live (L) Brown, Earth, and Neutral (N) Blue terminals on the terminal block
- Now prepare and drill two fixing holes onto the mounting surface
- Using the fixings provided fasten the base plate onto the wall until secure
- When base plate is in place replace the luminaire onto the mounting base and secure in place with the grub screw loosened off in stage 1 (see fig 1). After the grub screw is tightened ensure the fitting is in place and secure
Turn on Power and Test Luminaire
DIMENSION
Lamp Details
- KSR7164 – 6W LED Module, 220 Lumens 3000K Warm White
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced
CONTACTS
- KSR Lighting Aftersales: 023 92 674343
- E-mail: aftersales@ksrlighting.com
- ADDRESS: KSR Lighting Ltd, Unit E Hazleton Interchange, Lakesmere Road, Horndean, Hampshire, PO8 9JU
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>