KSR LIGHTING KSR1286-87 Surface Wall Light Instruction Manual
- June 9, 2024
- KSR LIGHTING
Table of Contents
KSR1286-87 Surface Wall Light
Instruction Manual
KSR1286-87 Surface Wall Light
Read these instructions before commencing installation. Please give these instructions to the owner/occupier after installation to retain for future reference/maintainence.
2x3W LED 240VAC~50hz
These fittings are Class I and require an Earth connection
Important Information
It is recommended that these luminaires are installed and fitted by a
qualified electrician ensuring the installation complies with current IEE
wiring regulations & local building control. These products are designed for
connection to a 240V~50Hz supply.
Any faulty, broken or damaged luminaires should be replaced immediately.
KSR will not accept responsibility for any claims arising from a poor
installation.
Please Note: The limited warranty shall be deemed null and void in the
following circumstances: Failure by the installer, end user or any third party
to exercise caution to protect any covered product or part from outside
damage, adverse temperature (normal operating ambient temperature -20 ~
+40°C), humidity conditions, fluctuations in the electrical system or physical
abuse as well as failure related to workmanship in the installation of the
products or parts.
General Maintenance
These products are suitable for external use, general maintenance and cleaning
should be performed at least quarterly.
Clean product outer using a damp cloth, do not use abrasive cleaners as this
may damage the finish. After any maintenance, remember to check all seals are
intact. Always switch off mains supply before servicing.
Do not use Megger or similar high voltage instruments. Due to the fact this
luminaire contains electronic components that maybe damaged by high test
voltages, they must be disconnected from the circuit before testing.
To prevent damage to the driver, do not mix with conventional magnetic
ballasts on the same electrical circuit.
At the end of life the luminaire is classed as WEEE under directive 2014/30/EU
and should be disposed of in accordance with local legislation.
Installation Procedure
Ensure mains supply is turned off.
Locate luminaire, Remove base by unscrewing 2x screws.
Place base on desired location locate and drill holes for wall plugs and fix
back plate to wall using suitable fixings.
Terminate the wiring into teh terminal block as follows: L-Live (Brown),
N-Neutral (Blue) & Earth – (Green/Yellow) as per Fig 2.This luminaire must be
earthed.
Pass wire through grommet and fix fitting to base, replace 2x screws removed
in first stage. Ensure sealign washers are replaced and in place.
Turn on mains supply and test.
Coro Surface Wall Light
Available Finishes: 316 Stainless Steel
| Lamp Details
Lamp Cap: LED
LED Wattage: 2 x 3w
Lamp Colour: 3000K
Lumen Output: 262lm
---|---
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced
This product contains a light source of energy efficiency class F
KSR Lighting Ltd, Optimum House, Beeding Close, Southern Cross Trading Estate,
Bognor Regis, West Sussex, PO22 9TS.
06.12.2022-PJL
Drg No. KSR1286-87-IS-D
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>