AUDIO HX12 EVO High End Subwoofer User Manual
- June 15, 2024
- audio
Table of Contents
AUDIO HX12 EVO High End Subwoofer
Specifications
- Weight: 9 Kilograms
- External Diameter: 312 mm (a)
- Installation Diameter: 285 mm (b)
- Magnet Diameter: 155 mm (c)
- Total Installation Depth: 177 mm (d)
- Installation Depth: 155 mm (e)
Power
- Music RMS Power: 2x 300 Watts
- Sensitivity (SPL): 90 dB
Congratulations on purchasing a high-quality
- AUDIO SYSTEM product incl. GERMAN SOUND. Important: Completely read this operating instruction before installation and use of the device.
- Attention : Pay attention to advices and instructions of the car manufacturer. Check the polarity when connecting the speakers. Important: You will need your purchase receipt as proof of purchase for any and all warranty repairs and for
- insurance purposes. Keep your receipt, owner´s manual and packing materials in a safe location for possible future use.
- Attention : Use of sound components can impair your ability to hear necessary traffic sounds and may constitute a hazard while driving your automobile. AUDIO SYSTEM GERMANY accepts no liability for hearing loss, bodily injury or property damage as a result of use or misuse of our products.
We recommend installing the equipment by an authorized service center or dealer. A professional fitting and connection is the requirement for further warranty and perfect sound.
Mechanical Installation Tip
- Warning : First disconnect negative pole of your car battery. Check-polarity, changing polarity may cause serious damage to your car electric. Best speaker positions are the original build in positions. Easy installation and original look are the reasons. Please note that the speakers are installed flat and stable. The quality of the installation decides very much the sound, therefore, attention should be paid to insulation and care during installation. Please note that the speakers are protected from heat, sunlight, mechanical influences, moisture and wetness by accessories from AUDIO SYSTEM.
- Attention : Install all cables as straight as possible without squashing or laying them over sharp edges. Otherwise this can cause short circuit or damages to your whole installation. Attention: Be careful removing original plastic parts of your car.
- The fitting parts could be damaged and have to be replaced. Important: The right polarity of all speakers is extremely important for the sound of your car audio system. We recommend changing polarity of the tweeter finding out the best possible sound.
- The best is to listen and/or to measure it.
Specifications
Weight
- 312 mm External Diameter ( a )
- Installation Diameter ( b )
- ( c ) 155 mm Magnet Diameter ( c )
- ( d ) 177 mm Total Installation Depth ( d )
- Einbautiefe ( e ) 155 mm Installation Depth (3e )
- Membrane HPPC-Papier HPPC Cone Speaker Cone
- Sike Elastomer Surround/Edge
- Die-Cast Basket
- Nomex Nomex Spider
- Kapton Kapton Coil Former
- Dust Protection Cap
Specifications
Watt Power
- RMS 2x 250 Watt
- SPL (2,83V, 1m) dB 90 dB SPL
- F b 20-1 000 H z Frequency Range
- Re 2x 2.1 DC Resistance
- Nominal Impedance
- Fs 33 HZ Resonance Frequency
- +/ – 1 2 mm X-Max Linear Excursion
- Q Factor
- Electrical Q Factor
- Total Q Factor
- Mms 145 Gramm Moving Mass
- Vas 35 Liter Equivalent Air Volume
- Tm Force Factor
- 435 cm² Effective Membrane Surface
Recommend Cabinets
- All calculations including woofer and bass reflex tube
| sealed | VG | 29 | Liter |
|---|---|---|---|
| Bass Reflex | Ft | 38 | Hz |
| --- | --- | --- | --- |
| VBR | 40 | Liter | |
| d | 90 | mm | |
| L | 250 | mm | |
| Band Pass | Fm | 54 | Hz |
| --- | --- | --- | --- |
| V1 | 30 | Liter | |
| V2 | 15 | Liter | |
| d | 90 | mm | |
| L | 200 | mm |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>