USX-MOUNT XFL009 Fixed TV Wall Mount Instruction Manual

USX-MOUNT XFL009 Fixed TV Wall Mount

If you have any questions along the way, just message to us. We’re ready to help!

CAUTION: PLEASE READ ENTIRE MANUAL PRIOR TO USE AND SAVE THESE INSTRUCTIONS

Product dimensions

Parts and Hardware

WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts!

NOTE: Not all hardware included will be used.

Attach Brackets to TV

Assemble Wall plate

2A Attach Wall Plate to Wall Wood Stud Option

CAUTION: Avoid potential personal injury or property damage!

• Drywall covering the wall, must not exceed 5/8 in. (16 mm)
• Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm)
• Maximum horizontal space between fasteners: 24 in. (609.6 mm)
• Stud center must be verified

1. Locate your studs. Verify and mark the center of the stud by finding the stud edges using a thin nail, or an edge-to-edge stud finder.

2. Position the wall plate unit at your desired height and line up the holes with your stud center line. Level the wall plate and mark the hole locations.

3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
   IMPORTANT: Pilot holes must be drilled to a depth of 2.5 in. (64 mm). Be sure to drill into the center of the studs.

4. Install wall plate 07 using lag bolts 01. Tighten the lag bolts only until they are pulled firmly against the wall plate.

CAUTION: Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.

Go to STEP 3 on.

2B Attach Wall Plate to Solid Concrete Wall

CAUTION: Avoid potential personal injury or property damage!

• Mount the wall plate assembly unit directly onto the concrete surface
• Minimum solid concrete thickness: 8 in. (203 mm)

1. Position the wall plate unit on the wall at your desired height. Level the wall plate and mark the hole locations.

2. Drill four pilot holes using a 3/8 in. (10 mm) diameter masonry drill bit.
   IMPORTANT: Pilot holes must be drilled to a depth of 2.5 in. (64 mm ).

3. Insert anchors.
   CAUTION: Be sure the anchors are seated flush with the concrete surface.

4. Insert wall plate 07 using lag bolts 01 . Tighten the lag bolts only until they are pulled firmly against the wall plate.

CAUTION: Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.

Wall Plate Installation Integrity Test

Before hanging TV, please conduct “wall plate installation integrity test” first.

Hang and Secure TV to Wall Plate

Take Down the TV from the Mount

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>