tienda MERY DM00210 Wireless Password Transmitter User Manual

tienda MERY DM00210 Wireless Password Transmitter

Operating instruction

1. Transmit open signal method: Input passwords, and then press open button.
2. Transmit close signal method: Input passwords, and then press close button.
3. Transmit stop signal method: Don’t need to input pass words, just only press stop button.

Instruction:
Press 0-9 button will have one short tick loud, press stop button or input the correct passwords and then press open and close button will have one long tick loud. If input the wrong passwords, press open and close button will have five short ticks loud.

Password setting method

(The initial password is “11”)

1. Press 1 button, after one short tick loud, and then press open button, hear five short ticks loud.
2. Keep pressing stop button, then press open button, after one long tick loud, and then release stop button.
3. Input the initial password, press open button, one short tick loud.
4. Input new password (the longest password can up to 8 digits.), and then press open button, one short tick loud.
5.  Input new passWord again (the longest password can up to 8 digits.), and then press open button, if one long tick loud means password updated successfully

Note:

1. If we don’t need the password, don’t input new password in the fourth and fifth steps of password setting and just only press open button.
2. All steps are required to be completed within 8 seconds, if the operation timeout and light goes out, then we need to restart the operation from the first step..

Undervoltage prompt

• When operating the transmitter, hearing the sound different from tick loud, that is undervoltage tick loud, please replace the battery
• Any state, press password recovery button for 5 seconds, after one long tick loud, then password will return to 11(Picture 2)

V. Matching methods between the controle and the transmitter

(In the same way as add transmitter)

1. Dip switch matching method: Setting a code on the board of the controller to consistent with the code on the transrmitter, then it may be operated (Picture 2)
2. Learning code or rolling code matching method: press Code key on the board of the controller for 1 second or press lock button and down button of the transmitter for 3 seconds, after one long tick loud, press stop button for 1.5 seconds, if one “tick” loud means matching Successfully.

Transmitter decomposition step

1. Use a flat object (such as a flathead screwdriver) from dark buckle to tilt PVC up.
2. Take off the cross screw of the fixed upper cover
3. Take down the transmitter upper cover.
4. Take off the cross screw of the fixed circuit board.
5. Take out the transmitter circuit board.
6. Replace battery or recovery initial password.

Structure diagram of transmitter

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>