ICE-WATCH Hydrogel Screen Protector User Guide
- June 14, 2024
- Ice-Watch
Table of Contents
ICE-WATCH Hydrogel Screen Protector
Product Information
Specifications
- Product Name: Hydrogel Screen Protector
- Compatible Device: ICE smart one (watch not included)
Product Usage Instructions
Installation Steps
- Clean the watch screen with the cleaning cloth provided, and remove dust by the dust remover.
- Stabilize the watch on a flat surface using the ring provided.
- Place the hydrogel film on the watch screen, aligning it properly. Press the “Position Line” in the middle.
- Repeat the same steps for the other half of the screen. Use the squeegee to remove excess bubbles.
- Remove the surface film and smooth the edge if necessary.
Frequently Asked Questions (FAQ)
Can I use this screen protector with any other smartwatch?
No, this hydrogel screen protector is specifically designed for Muse with
ICE smart one only. It is not compatible with other Msmartwatches.
How do I clean the watch screen before installation?
Use the cleaning cloth provided to gently wipe the watch screen and remove
any fingerprints or smudges. Then, use the dust remover to eliminate any dust
particles.
What is the purpose of the “Position Line”?
The “Position Line” helps you align the hydrogel film accurately on the watch
screen. Press it in the middle to ensure proper placement.
How do I remove excess bubbles after applying the hydrogel film?
Use the squeegee provided to scrape off any excess bubbles that Mmay have
formed during the installation process. Make sure to do it Mgently to avoid
damaging the film or the watch screen.
Can I remove the screen protector once it’s applied?
Yes, if you wish to remove the screen protector, carefully peel it off from
one corner. Start from the edge and slowly lift it away from the watch screen.
Clean any residue left behind using the cleaning cloth.
Installation Steps
Step 1:
Clean the watch screen with the cleaning cloth provided, and remove dust by
the dust remover.
Step 2:
Stabilize the watch on a flat surface by the ring provided.
Step 3:
Place the hydrogel film and align it to the watch screen, press ‘←Position
Line→’ in the middle.
Step 4:
Lift ➀ up to be over 90º to the screen. Press the squeegee evenly to stick the
hydrogel film to the first half of the creen and remove the base film at the
same time from ‘←Position Line→’.
Step 5:
Do the same to the other half ➁. Scrape off excess bubbles by the squeegee.
Step 6:
Remove the surface film, smooth the edge if necessary.
For ICE smart one only, watch not included.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>