Ice-Watch ICE digit Retro Raspberry Sorbet Instruction Manual
- June 13, 2024
- Ice-Watch
Table of Contents
Ice-Watch ICE digit Retro Raspberry Sorbet
ATTENTION
- Never try to open the case or remove its back cover.
- Do not operate buttons underwater.
- Should moisture appear inside the watch, have it checked immediately by your dealer. Otherwise, it can cause erosion of the metal parts of the watch.
- Though the watch is designed to withstand normal use, you should avoid rough use or dropping the watch.
- Avoid exposing the watch to temperature extremes.
- Wipe the watch with a dry, soft cloth only. Avoid allowing it to come into direct contact with chemical materials, which can cause deterioration of the plastic parts of the watch.
- Avoid wearing the watch in electromagnetic, static conditions.
- The information contained in this document belongs to ICE Universal Ltd and may not be reproduced without its authorization.
- WATER RESISTANT: 30m
- BATTERY: CR1616
General functions
- USE THE BACKLIGHT: press and hold C to illuminate the display
- DISPLAY THE DATE: press and hold D to display: Year, Month, Date
- DISPLAY THE ALARM TIME: press and hold B
- ON THE ALARM AND CHIME: press one time B and three times D
- OFF THE ALARM AND CHIME: press one time B and one time D
- DISPLAY DUAL TIME FOR OTHER TIME ZONE: press B three times
TIME SETTING
-
Press and hold A until the seconds flash (flashing indicated in set mode)
-
Press D to reset the seconds
-
Press B to change to the next election
-
Press D to increase the number, press and hold to increase at high speed
-
Repeat steps 3 and 4, the selection in the following sequence:
SECONDS › HOUR › MINUTES › YEAR › MONTH › DATE -
Press one time A to return to the time screen
- In the «Time Setting Mode», press A to switch between 12/24H formats.
ALARM TIME SETTING
- Press one time B to access the « Alarm Mode »
- Press A the hour to flash (flashing indicated in set mode)
- Press D to increase the hour, press and hold to increase at high speed
- Press B to select the minutes
- Press D to increase the minutes, press and hold to increase at high speed
- Press one time A and three times B to return to the time screen
SNOOZE
- The alarm sounds at the present time each day for about 60 seconds.
- Press any button to break it.
STOPWATCH
LAP TIME
- Press two times B to access the « Stopwatch Mode »
- Press D to start the stopwatch
- Press D again to stop the stopwatch
- Press A to reset the stopwatch
- Press one time A and two times B to return to the time screen
SPLIT TIME
-
Press two times B to access the « Stopwatch Mode »
-
Press D to start the stopwatch
-
Press A to display the split time, stopwatch timing continues internally
-
Press A to clear the split time and to continue the time measurement
Repeat steps 3 and 4, you can measure the multi-split time -
Press D to stop the stopwatch
-
Press one time A and two times B to return to the time screen
DUAL TIME
- Press three times B to access the « Dual Time Mode »
- Press A the hour to flash (flashing indicated in set mode)
- Press D to increase the hour, press and hold to increase at high speed
- Press B to select the minutes
- Press D to increase the minutes (press once to change 30 minutes)
- Press one time A and one time B to return to the time screen