ice-Watch 6p29 Boliday Grey Shades User Guide
- May 15, 2024
- Ice-Watch
Table of Contents
ice-Watch 6p29 Boliday Grey Shades
Getting started
Remove the plastic stopper (in the direction of the arrow).
Instructions
Ice-Watch must be serviced regularly in order for it to work correctly. The length of time between services will vary depending on the model, climate and the care you take of your watch. As a general rule, we recommend the following steps so that you can keep your watch in tip-top condition for as long as possible.
- Temperature: avoid temperatures below 0°C (30°F) or above 35°C (100°F).
- Avoid prolonged exposure to sun, steam, contact with alcohol, detergents, perfume or cosmetic products to prevent distorzion, discoloration or any damaging reaction.
- Use within 5 ATM water resistant standard.
- The information contained in this document belongs to ICE Universal Ltd and may not be reproduced without its authorization.
-
A) SETTING PROCEDURE
DAY › HOUR & 24 HOUR › MINUTE & SECONDE › DATE -
B) SETTING THE DAY
1. Pull the crown out to the 2nd position to stop the second hand at 0 (12 o’clock).
2. Turn the hour/minute hands in a clockwise direction to set a day.
3. In order to set the day, you must advance the hour hand by 24 hours per day.NOTE : If the day is set by turning the crown counterclockwise, there is the possibility the date will not change over. Do not set the day by turning the crown in countclockwise direction. The day changes somewhere between 0:00a.m. and 5:30a.m. or a little later.
- C) SETTING THE TIME
1. Gently pull the winder out to the 2nd position.
2. Turn the winder to set the hour and minute hands to the correct positions.
3. The second hand starts again when the winder is pushed back into its normal position.- NOTE : Make sure you have correctly set AM/PM before setting the time. When the day changes over, it is a.m.. (Day changes over between 0:00a.m. and 5:30a.m. or little later). Check am./p.m. by the 24hour hand.
- D) SETTING THE DATE
1. Gently pull the winder out to the 1st position.
2. Turn the winder anticlockwise to set the date.
3. Return the winder to its normal position.- NOTE : Do not set the date between the hours 9:00p.m. and 0:30 a.m.. The date may change correctly the next day.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>