VISUAL COMFORT JN 5006 Alberto Large Two Tier Chandelier Instruction Manual

VISUAL COMFORT JN 5006 Alberto Large Two Tier Chandelier

ASSEMBLY INSTRUCTIONS

1.  Carefully remove all parts from the box. Place on a clean, soft surface.

2.  Remove collar loop (D) from chain (G) by removing quick link (N).

3.  Install mounting plate (B) to junction box and secure with mounting screws (C).

4.  Secure collar loop (D) to mounting plate (B) using pliers to tighten locknut.

5.  Install canopy (E) to collar loop (D) and secure with collar ring (F).

6.  Connect quick connector (K & L) together, then install fixture top tier (I) to bottom tier (M) and secure with screws (J).

7.  Determine desired overall length, and amount of chain (G) needed. Shorten chain using chain pliers. (Keep extra chain)

8.  Attach chain (G) to collar loop (D) and fixture loop (H) using quick links (N). Secure quick links (N).

9.  Thread fixture wire and ground wire through chain (G).
   NOTE: When you reach the collar loop (D), ensure there is no tension on the wires. Cut excess wires, being sure to leave about 12” to reach the junction box.

10.  Separate two sides of molded wire, and strip insulation on each 5/8″.

11.  Loosen collar ring (F) and let canopy (E) slip down chain (G) carefully

NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver
• Chain Pliers
• Slip Joint Pliers
• Measuring Tape
• Wire Cutters
• Wire Strippers

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>