VISUAL COMFORT CHO2942AI-CG Chapman and Myers Fresno LED Wall Lantern Instruction Manual
- October 30, 2023
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT CHO2942AI-CG Chapman and Myers Fresno LED Wall Lantern Instruction Manual
ASSEMBLY INSTRUCTIONS
Fresno Large Tall 3/4 Wall Lantern
Item # CHO 2942
NOTICE :
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED) :
Phillips Screwdriver
Hammer
Slotted Screwdriver
Drill
Pencil
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture (G) by removing screws (F).
-
Using mounting plate (B) as a guide, line up with the junction box and mark anchor positions.
-
Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes using hammer.
-
Install mounting plate (B) to the junction box and secure with mounting screws (D), then secure wood screws (C) to anchors (A).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (E).
NOTE : It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (E).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (E).
CAUTION : Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (G) to mounting plate (B) and secure with screws (F).
-
Install light bulbs into the sockets.
-
Remove metal bars (H) from fixture frame by removing screws (I) as shown in diagram 2.
-
Install glass panels (K) to fixture frame by securing with metal bars (H) and screws (I) using provided wrench (J).
NOTE : Do not overtighten otherwise glass could become damaged. -
Install glass panel (L) to fixture frame by securing with metal bars (H) and screws (I) using provided wrench (J).
NOTE : Do not overtighten otherwise glass could become damaged.
FOR OUTDOOR/WET LOCATION INSTALLATION: -
Using silicon compound, apply a small bead where backplate meets the wall to prevent water from entering.
NOTE : Large gaps will need to be corrected before applying silicon compound.
Care Instructions : Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>