BORMANN BEH5050 Elite ECO Convector Panel Heater User Manual
- June 4, 2024
- BORMANN
Table of Contents
BEH5050 Elite ECO Convector Panel Heater User
Manual BEH5050
030706
Safety Instructions
Before using matt sere to road att of the below norucnom In order to avoid near’, ot darrs>,;e. and to get the best results from the appliance. Make sure to seep tninynux In a safe oboe. if you give or transfer this appliance to someone else make sued to aka include ten manual In case of damage caused by user fame to follow the instructions es the marb4 the warranty MI be mad The manufacturer/importer accepts no liability for damages caused by Wire to brow the manual, a negligent use or use rot In accordance with the requirements of this manual
- Tres appliance can be used by CRO arena aged from 8 years and abort and person soh reduced phi b be. sensory or mental capabilities or tack of events-nee and Lockridge If they have Guar to super0Pon or intrusion concerning…se of the appliance ei a safe way and understand the harass role se
- Children TN rot play with the AP Askanc
- Clea✓g and west maintenance shall not be made by/Oren without superesion
- Children of less than 3 years should be kept away unless continuously superset.
- Children aged from 3 years and less than 8 years had only sw. len on off the acutance provided that n has been CANS or Insured In its 444,1444 normal operating p:45011 and the/ have been given supervision or eat-non concern.% used the appliance d tare soy and understand the hazards Lourdes Children aged from 3 years and less than 8 years PIA not plug A. regulate and clean the appearance a perform user mantenance
- CAUTION – Some pans Of thin products can become very hot and cause a loom Particular Mention has to be even where children and vulnerable people are present.
- If the IOPPIYCOrd in damaged. It must be replaced by the manufacturer. its service agent or umearrychsalhe0 persons Nora/ to avoid a hazard
- WARNING n order to avoid metering, do not covet the hexer.
- Do not use dos heater In the immediate sorroolorg of a bath, a shower or a swimming pool
- The heating *glance must not be sated oast below an <Cutout outlet.
- Means ’00 NOT COVER’
- Settee inserts the ego into the men so<km, please check that Om voltage and frequency comp/ month the specifications on the rating ‘abet.
- Doannea the mains plug from the soon: when an apparent 4 not In use and before among.
- Insure that the maim carte It not hung nor: harp edges and beep It away from hot [Elects and open flames. IS.
- Do not meet..< the appliance or the malt OLI/portatif Or miser ‘quids. There is danger tont* Ow toNKtme shock
- To /Mate the plug from the plug socket, pull MC 21400 no: poll the power cord
- Do no: touch the appliance if n fats into wale, Pernonetrc 44.6 tram ms scan. turnoff the appliance and send It to an author:al service center for repair.
- Do not pug or un prog the appliance from the detrital eaglet felt a hand.
- here, attempt to open the Novas of the pp.1 arse re a•• co Tres could cause electric sho
- Never leave the appliance unattended Panto use
- The app once 4144 is designed for commercial use.
- Do not sas the appliance for other than intended us
- Do not wind the cord around the appliance and do not bond it.
- The neater a not intended for use in bathrooms. Laundry area, fed mw Wet indoor to carom Never pace the heater *bete it may fall into a bathtub or any another water container
- Do not use outdoors
- Do not cover or obstruct any of the heat outlet gilt or the ar intake°
- .Do not Oars the heater on carpets Otth a very stet, p..*
- Do not! men try object through the heat whet or a‘ intake cites of the Ileac
- Do not use the Mater In areas where no note bo. tos are stored or where flamrrad c ft he’s ma Sc paler*
- Particular care stupid be Taken when the heater Rsduated n areas occupied ‘ends d .:ableo person
- Alxoys unplug the heater when rent it from one location to another
- The hexing CK, ice It net suitable for assembles In ‘theses and math nes.
Pads Description
- Contra pa e< and agnaldaptn
- Main power switch
- Warm au outlet
- .feet
- Wheel
- ReMOteCOntra
Control Panel and Digital Display
A 0Woll bison
B. Tuner Batton
C. Power setting
D Temperature stepbro
f Temperature strong
E Child tack
G. Main power ican
H. Set temperature or timer display
I. High heat
J. Low heat
K. Room temperature display
L. Child lock icon
Remote Control
This unit has a remote control. Please use one piece of CR2025 battery for
this remote control.
Please insert the battery to the remote control tightly (Refer to the
instruction behind the remote control). If it is not in use for a long time,
please take the battery out of the remote control.
A. On/off button
B. Power setting
C. Timer setting
D. Temperature setting
E. Child lock
Feet Assembly
Take the appliance upside down. Attach the two feet to the bottom of the
appliance and fix them with the provided screws. Insert the four small wheels
into the two feet.
Operation
Plug the appliance into an appropriate electrical outlet. Turn on the
appliance by pressing the main power switch.
A beep sound will be heard, and in the meantime, the room temperature shows in
the display. Press the button , the heater is turned on.
Power setting
Press the button to choose your desired power, the button to choose your
desired power is on display: on behalf of low heating; the is on display, on
behalf of high heating.
Temperature setting
Press or button on display: behalf of low heating; the is on display, behalf
of high heating. button or then shows in the display.
Time setting
Press the button to set the desired working time from 0h to 24h. The set
working time will flash a few seconds and then shows the set temperature
again. The appliance will shut itself off automatically when the time is up.
Long press the child lock button until a beep sound is heard, and the child
lock function is activated.
Long press the child lock button again until a beep sound is heard, and the
child lock function is canceled.
Turn Off
Press button again to turn off the appliance. Then, turn off the main power
switch and unplug the appliance.
Safety System
- The appliance has a safety system that automatically switches off the unit when overheated.
- If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down for at least 30 minutes. Put the plug in the socket and switch on the heater.
Cleaning
- Before cleaning the item wait when it cools down and plugs out
- Do not use abrasives and solvents. Wipe the product with soft wet cloth
- It is necessary to remove dust from the surface regularly
- Washing the item and placing it in water is forbidden!
- If you are going not to use the heater for a long time, wipe it surface and put the item in the color box.
- It should be placed in a dry ventilated room. Avoid high humidity and mechanical impact on the item
Attention: never leave the heater unattended!
The importer retains his right to make changes in the appearance and
completeness of the item without preliminary notification to the customer.
The item is for household use only.
Attention! The manufacturer does not assume any liability for any damage
caused directly or indirectly by not following this instruction manual,
general safety rules, or interference in the construction of the product.
Storing the Heater
When the heater is not used for a long time it should be protected from dust
and stored in a clean dry place.
Technical Data
Heat Settings| 1000/2000W
Display| LED
Timer| 24h
Thermostat Control| Adjustable
Over-Heating Protection| Yes
Waterproof| IP24
Remote Control| Yes
The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products. The parts described/illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
- Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. * To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair r replacement work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer. to set the desired temperature from 16oC to 40oC. When it reaches you set your desired temperature, it will flash a few seconds, and
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>